Rebar Owner's Club (pic heavy)
-
Thanks for that, Poncho!
I’m like a giddy school kid thinking about adding scissors to the Rebar.
I’m just concerned that a pair of wrenches for the Rebar is gonna cost USD40 while the spare scissors from a junker is only USD20, all from a local seller up north.
Not sure if I have anything else that’ll work on the binders of the Rebar.
-
Great pics again !

-
Thanks Steve

-
Do like that coyote tan…if i didn’t already have both BO and silver …

-
It looks so much better in person
:D -
Would a Wave’s large bit changer be a drop-in replacement for the philips of a Rebar?
-
I believe that they are the same width and should be a straight drop in

-
Halfway done…..am I doing this right?
Gonna have to open it up again tomorrow to make some slight adjustments to where the awl is.

-
Looking good to me
sometimes it does take a few times shuffling the tools around to get everything to close correctly 
-
Final form!
Given:
- my only tools are the wrenches and SAK tweezers. No drills, dremels or anything of the sort.
- no spare washers
Puzzles:
- in the configuration in my previous post, the plier head touches the nail nick of the scissors. It closes but if you clam down firm enough, you’ll feel the scissors / plier head shift from being on top of one another to beside each other.
- philips and awl need to be in the center as they contour out of the way for the plier head.
- can opener (very important for me) has nail nick on right side only. It doesn’t have top side fingernail access like the awl or flatheads.
- when folded, the scissors have a thumb stud to its left.
Solution:
With plier head on top, sequence on one arm from left to right is:
Plain edge blade
Can opener
Small flat head
Awl
Large flat head
FileThen:
Serrated blade
Philips
Spacer
Scissors
Wood sawTool clumping on the awl-flatheads-can opener? Yes, thank you very much. Actually helps with tool deployment. The scissors cut and does not get disconnected from the spring.
Basically, I think it’s a success and worth the money and effort.

-
Looks good!

-
Definitely a win

-
Thanks everyone

I have to admit that I’m exhilarated such that it feels I have a totally new LM.
I’m thinking of saving up a bit more and getting a large bit holder from a Wave so that the Rebar can use the ratchet driver and bit kit. I’m picturing it as something along the lines of an ST300M.
-
That sounds like a very good plan, Zephon; a Rebar M.
Keep us (me!) posted!

-
I had a plain one for today.

-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


