Rebar Owner's Club (pic heavy)
-
Thanks Steve

-
JD's and Coyote Rebar...


-
@Dutch_Tooler said:
Nice - really dig the coyote tan Rebar
They really look great in person
thanks, DT 
-
@Dutch_Tooler said:
Hi Zephon,Like this :D

@Juan el Boricua said:
JD's and Coyote Rebar...
Cool pic, Juan

-
Niiiceee pictures, Poncho, nice!!!

-
Thanks Juan

-
What’s the ‘right’ way to place the Nite Ize clip on the Rebar?
Why is it always on the ‘tool side’?
Why not on the plier side?Ergonomics?




-
Glad you have the Rebar "pocket clipped", Zephon!

I'd guess that (at least, for me) it interferes with the holding as it gets in the way of the thumb and, having that much gap between tool and clip; its an invitation for it to get snagged at everything, the squared floating end would feel uncomfortable, and if it were to ride on the flat, it would end up protruding too much from the pocket which is unsightly and easier for it to fall off. But remember, this is just my opinion.

If you don't mind me asking, where did you got the black clip?

-
Glad you got a clip
The BO one I have with a clip seems ok, let me see if I have a pic of it with the clip
It covers the words up on one side (I bought it with the clip already on) and although it is a good spot that does bother me a bit
:D -
Found a pic


-
I prefer the look and placement of the Kick clip on this one because it is a bit more aesthetically pleasing butthw Nite Ize clip is probably more correct for a right handed pocket


-
It’s actually a stainless clip, not a black one. Must be the reflection or lighting when I took the picture.
Anyway, I attached the clip this morning after breakfast. I removed the magnets I glued on for the long MUT flat/philips bit. I attached it on the saw side of the tool, where the LM branding is at. I also made the ‘locks’ the point of reference so the rectangular edge of the clip run continuous with the edge of the lock. That way the clip isn’t supposed to interfere with any round corners.
I’m also not too crazy of the Nite Ize brand so I took a 150 grit sandpaper to remove the logo on the clip, then finished it off with a 2,000 grit to match the texture of the Rebar.
The clip is bigger than expected and I think would even hold up a Super Tool 300 (as if you can clip carry that one).


Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login





















