Lansky guided system
-
I can't seem to find the other one I am thinking of
I know that someone else tweaked a Lansky system on here 
-
I'll search some more and look through what I find, Thanks again

I also sent a message to Lansky, if I get an answer I'll post it here in case anyone might need it later

-
There is a lot of info in this thread from another site.
Spoiler:
https://www.edcforums.com/threads/some-lansky-sharpener-tips-warning-pic-heavy.98802/ -
Thanks Aloha

Sent fra min M2002J9G via Tapatalk
-
@RF52 said:
Anybody that has the guided system from Lansky and have knowledge of unc/unf screws and could tell me what size and threads they use?
Having problems clamping full flat grind blades
Thanks in advance

Sent fra min M2002J9G via Tapatalk
Haven't seen awl the other posts, but how about having some leather between the clamp and the blade? It might do the trick.

-
I'll give it a try, thanks
The problem is that the blade wobbles in the clamp, the leather may fix that 
Sent fra min M2002J9G via Tapatalk
-
One thing I'll say is to be careful not to tighten the screws too much, or you'll strip the threads in the aluminum clamp. Ask me how I know.

-
I have heard that from others as well that I'm sure found out the same way

Sent fra min M2002J9G via Tapatalk
-
I love the Lansky system for smaller blades. I find it really fails on larger blades, unless of course you use multiple clamps.
Still, it's a great system. I traded mine away years ago and I still miss it.
Def
-
The reply I got from Lansky is 10/24*5/8, which doesn't tell me much...
Anyone willing to give it a try translating it for a metrics guy?
Sent fra min M2002J9G via Tapatalk
-
@RF52 said:
The reply I got from Lansky is 10/24*5/8, which doesn't tell me much...
Anyone willing to give it a try translating it for a metrics guy?
Sent fra min M2002J9G via Tapatalk
If these thread into a tapped hole in the clamp, there is no conversion, if that's what you mean.
This is a #10 screw, 24 threads per inch, 5/8 inches long. -
That was just the answer I was looking for
Just needed to know what was what of the numbers 
Sent fra min M2002J9G via Tapatalk
-
One thing I found that helps with my Lansky is using a 2-3" piece of electrical tape on the spine of the knife, helps avoid scratches and holds it nice and tight.
-
Thanks

Sent fra min M2002J9G via Tapatalk
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login