Seeking pouch recommendations
-
@GearedForwards said:
I'd also advise you to look into camera pouches.That could be a worthwhile option. I can, however, see one problem with them: there is high likelihood that the tools would bash up against one another.
I think the hardest part of your request is keeping the top of the pouch under your waistband as a limit, but you could always use a dangler maybe?
Very true. I suspect I'm in the minority as regards that height limit. Whether a danger would be an additional annoyance, I'm not sure.
-
So I dont see any part of your loadout requiring a Huge pouch?
There are just a few tools in there that you list at least and even the Large Skinth L Shield might be bigger than you need and it is not really that huge either.
A Skinth from the Shield series seems ideal to me as you do not want side pockets and though these do have them,they are not just open tubes but are flat and if not in use are also not even noticed.I am confused about the tools bashing into each other too? They are tools so why does this matter unless it is noise?
I think as long as you dont get too huge a pouch though this should not be a problem at all.And then there is the lower than your waistband requirement.
Most pouches with a pocket clip,like a Skinth will sit at or a hair above that spot maybe but again,why this need exactly?
I carry a Skinth with pocket clip every day for years now and this has never even occurred to me as an issue. -
You might consider checking out options for MOLLE pouches designed for tourniquets, torches (or flashlights, for them what's in the US), mace cans, and similar.
A good number of the European-made ones have PALS right at the top, and using a separate strap method like a Malice clip or a Maxpedition TacTie would put the pouch slightly below the top of a belt, and so a bit lower than the waistband. They also have similar ones designed around mini IFAKs and the like, which are more likely to have inner elastic loops or internal dividers.You could even spring for a custom pouch made to your exact specifications. Poland has some great makers who knock up fantastic kit and prices are very good, often far cheaper than the Maxpedition or Skinth equivalent and with a far wider range of options.
-
To answer those questions asked by ezdog: no, I don't require a huge pouch. Noise is a factor with tools banging into each other, but the main thing is what I view as unnecessary wear. And the height thing? I have had jobs that required me to bend, twist, and lean in all manners. Because of that, I prefer to have my pouches and sheaths ride low so they don't dig into my side and annoy me. That was also one of two reasons I got rid of one of my knives last year...
I'll look into MOLLE gear as well. I believe the awlsome Leatherman sheath I mentioned previously is a MOLLE type.
-
With or without a flap to hold everything?
JR -
I also dont care for my tools bashing about. Might just be a thing with some of us. That said, I hear you on the height of sheaths. I like my fixed blades to ride low. I use danglers for that very reason.
-
@Farmer X said:
To answer those questions asked by ezdog: no, I don't require a huge pouch. Noise is a factor with tools banging into each other, but the main thing is what I view as unnecessary wear. And the height thing? I have had jobs that required me to bend, twist, and lean in all manners. Because of that, I prefer to have my pouches and sheaths ride low so they don't dig into my side and annoy me. That was also one of two reasons I got rid of one of my knives last year...I'll look into MOLLE gear as well. I believe the awlsome Leatherman sheath I mentioned previously is a MOLLE type.
Got it! I too work like that and my Skinth is rarely in the way though it can be too,anything that might get in the way of seat belts or tool belts is subject to that and just the nature of the beast I am afraid.
The reason I made the comment about too large a pouch is exactly what you said then,if too large the tools just float around and your stated load of tools is anything but huge honestly.
I bet you would be happy with a Skinth! -
I had this made a while back, not the best but it holds a lot, only thing is I don’t think they still make them? But I guess worth looking into?
JR
-
@MadPlumbarian said:
With or without a flap to hold everything?Definitely with a flap over all pockets. Your pouch looks like it could work. I'll check out Storm Industries.
My Morakniv Garberg rides pretty low in its factory sheath. A bit off topic, but that's an all around excellent fixed blade!
-
Just to shared to add to your options:
This pouch measures approx 5 inches across and about 6 inches high. It’s basically a copy of something Maxpedition produces but it’s sold at a fraction of the price. To be honest, I haven’t really stuck it thru my belt or do half-run or quick walks to see how the tools might juggle about. It’s more of how I store my MT’s on the shelf and how I spread them open on a surface when working on something. Stock pics so please bear with me.
First picture is a boring front view. Second pic shows the MOLLE back (which isn’t on the real Maxpedition).
Third would show the tool spread with pockets, elastic straps, etc. That’s a Rebar on the left side. Fourth would be same picture but with an ST300.Anyway, it fits a full size LM (or two), a SAK, a pen, and possibly even a flashlight and still have room to spare. It comes in black as well.
*The reason why the LM’s are in a separate pouch is that I sometimes don’t need the other tools and I want to pocket carry instead of belt carry.
Hope you find the perfect pouch for your needs!




-
@Zephon said:
Hope you find the perfect pouch for your needs!Me, too. Having taken a look from a different perspective, I may be able to get by with just my awlsome Leatherman sheath and a few slips for SAKs and traditionals. Something like a Skinth P1 might work if I could get one without the loop on the side.
-
The Leatherman pouch is made in conjunction with Pacsafe. In other words it is made by Pacsafe so have you tried looking up Pacsafe organizers to see what they have that might be close? Maybe review what was used in the last Batman Challenge where the challengers carried all of their assorted EDC gear on their belts for a month like Batman's utility belt. That was a good challenge that I hope we do again sometime. Perhaps repurpose some other products such as these I've tried, the dual magazine pouch or an old flip phone case or.... ? I will state, before you blame me for losing anything, that I needed to sew a bit of nylon strapping into the bottom of the old phone case after the Huntsman I had in there fell through the gap at the bottom, but there's been no issues since.


-
I recommend this:

That way you will not have to choose between your knives and MTs. You can carry them all with you, provided you have a strong back :D
This is what I use (Nite Ize XL Pock-its):


-
@Alan K. said:
Maybe review what was used in the last Batman Challenge where the challengers carried all of their assorted EDC gear on their belts for a month like Batman's utility belt.I'll find that thread sometime tomorrow (getting late here). Good suggestion...thanks!
@Adam5 said:
You can carry them all with you, provided you have a strong back :DLooks not unlike a military duffel bag (or as it was called in the Navy, a "sea bag"). Probably not practical for me, as I'm trying not to throw out my back again. But the Nite Ize Pock-Its XL may work.
-
@Farmer X said:
I'll find that thread sometime tomorrow (getting late here). Good suggestion...thanks!
Looks not unlike a military duffel bag (or as it was called in the Navy, a "sea bag"). Probably not practical for me, as I'm trying not to throw out my back again. But the Nite Ize Pock-Its XL may work.I gotchoo /topic/85814
I'm thinking of a similarish new challenge soon :ahhh
-
@GearedForwards said:
I gotchooThanks! I'll definitely take a read through that topic.
-
@Farmer X said:
I'll definitely take a read through that topic.And...done. I didn't really see much that would work for me, but I have a better idea of what I'm after.
I'm starting to think that my Leatherman sheath would work for the Leatherman. The main issue with SAKs is that I like to carry them in the hidden and divided pockets on my tactical pants, and some of them have a pass-through hole in the bottom. SAKs like to submarine their way through that hole, so I'm thinking of a slip, or maybe a suspension clip or a Kydex sheath, to help mitigate that problem. And I could carry a pen clipped to pretty much any pocket.
I still need to have a look at Pacsafe...but perhaps a pouch isn't the best option for me, after all?

-
@Farmer X said:
And...done. I didn't really see much that would work for me, but I have a better idea of what I'm after.I'm starting to think that my Leatherman sheath would work for the Leatherman. The main issue with SAKs is that I like to carry them in the hidden and divided pockets on my tactical pants, and some of them have a pass-through hole in the bottom. SAKs like to submarine their way through that hole, so I'm thinking of a slip, or maybe a suspension clip or a Kydex sheath, to help mitigate that problem. And I could carry a pen clipped to pretty much any pocket.
I still need to have a look at Pacsafe...but perhaps a pouch isn't the best option for me, after all?

Have you considered an elastic sleeve for the Leatherman? Would let you carry it horizontally so no part would rise above your belt. Otherwise I'd just get a slip with a pen loop for the SAK and pen personally, or if you really want to use the divided pockets, just throw a stitch in the bottom of one?
I didn't realise at first it was only three tools, unless you want to carry accessories for the LM a pouch to hold them all would likely be a but much.
-
@Farmer X said:
I'll find that thread sometime tomorrow (getting late here). Good suggestion...thanks!
Looks not unlike a military duffel bag (or as it was called in the Navy, a "sea bag"). Probably not practical for me, as I'm trying not to throw out my back again. But the Nite Ize Pock-Its XL may work.Yeah, I was looking for a pic of a sea bag since you were in the Navy (iirc
).The Nite Ize works well for me, and it doesn't rub my ample side saddles :D
-
@Adam5 said:
Yeah, I was looking for a pic of a sea bag since you were in the Navy (iirc
).You did recall correctly. I was in the United States Navy from July 2000 to September 2006. Served aboard USS Lake Champlain and USS Peleliu.
@GearedForwards said:
I didn't realise at first it was only three tools, unless you want to carry accessories for the LM a pouch to hold them all would likely be a but much.There is a possibility that a flashlight (or "torch," as the preferred term in Britian) could be added if and when needs dictate. For now, my little Olight fills the flashlight bill just fine. I may add a Leatherman bit set if needs dictate, but for now the ones supplied work just fine for me.
Incidentally, the problem of submarining may have been solved simply by getting an Opinel. It seems not to have that tendency due to its greater bulk. So, carry the Opinel in the divided pockets, the SAK in a separate pocket, and the Leatherman in the sheath. Provided the pen has a pocket clip, it can ride pretty much anywhere.
Now I'm starting to question if I need a pouch for day-to-day operations. I'd still carry one when camping...but that's probably a whole different type of pouch, and a consideration for at least a month down the road.
Thanks to awl for the feedback!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login