Which square driver for Rebar?
-
Hi guys, not been on for a while but I just found a NOS Rebar in my drawer I'd forgotten about!
I believe these were designed to take a square drive adapter on the Philips - can anyone enlighten me on this and what I need to look for to buy a generic one so I can use various 1/4" drive sockets or similar?
The square section seems to be around 5mm or 3/16".
My Wave adapter will fit but is a bit loose/clicky...
-
Hello.
Indeed, the square hole of the adapter is 5mm, so a common 1/4" square to 1/4" hex adapter will not fit.
The one you're after looks like this:
-
Many inexpensive multi-tools come with a bit adapter that fits the Rebar and many other multi-tools.
Check this thread:
/post/1732879 -
with RP 
Welcome back, Max

-
Thanks guys!

I have also just found a Chinese tool (the one ReamerPunch linked) I have with one of those bit kits - the square adapter fits but is poorly made so the magnet bit inside just gets pushed up leaving only a short female part for the bits to fit into (fall out of! :D ).
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login