Question on battery basics
-
sorry about the accidental double post
-
@fuyume said:
This really needs to be qualified. I have yet to see any rechargeable AA cell that can outlast an Energizer L91 lithium primary, whose capacity is on the order of 3000-3500 mah.Yep, that Energizer will beat my 2100 mah rechargeable Varta, no doubt. I was not aware of that model.
I was referring to my own experience with AAs from the nearest supermarket, best alkaline that are widely spread around here being Duracell and Toshiba probably. Which are easily outlasted by the above mentioned Varta by a great margin. -
Great discussion everyone! Replies are very much appreciated.
-
I generally use rechargeables and eneloops work well. Most current rechargeables work fine and I even had good luck a few years ago with some cheap 4000mAh :) or so eBay batteries.
Regarding alkaline AA capacity I did some tests a few years ago and not all are the same.
I choose Alkalines when there is a risk that the battery will be depleted totally, like if a child is using a cheap torch and they leave it on until the battery goes totally flat. This will seriously affect rechargeables, killing an expensive battery.
Some smart pieces of equipment will stop running before the battery is depleted, protecting it.
Rechargeables also work better in high current situations, like in camera flashes.There are some speSmurfpillsed rechargeables for low drain situations too, like in cheap, low lumen solar lights.
I also have 9V rechargeables for certain pieces of equipment, that work well.
Primary lithiums have great shelf life but tend to be expensive.
Most of my torches, the brighter ones use Li-Ions.
end of rumbling ....
-
@dks said:
I choose Alkalines when there is a risk that the battery will be depleted totally, like if a child is using a cheap torch and they leave it on until the battery goes totally flat. This will seriously affect rechargeables, killing an expensive battery.I understand alkalines are widely disparaged and shunned among the torch fanboy community, being known as alka[i]leaks[i] for obvious reasons.
I actually only have a few torches for which I use alkalines, one being an original E12 because it doesn't take any other, and two being Maglites that I've had since the early 90s and that come with memories. I usually use the el-cheapo multipacks from IKEA, again just because. -
Hi everyone, I have another battery basics question here.
Given: Lumintop Frog on a 10440 battery.
I got this tube that supposedly allows the Frog to use regular AAA batteries. Here’s the thing- the tube was designed for 2x AAA
BUT when assembling it to the Frog, the said AA tube attaches to the head then the 10440’s body attaches to the tail end of the tube. To make the batteries come in contact, a total of 3x AAA are physically needed.
My question is that ‘will it work?’ Does can a light powered by a single 10440 be replaced with 3pcs AAA?
I tried it but it didn’t light up so I’m trying to see if it’s a physical problem (tube is a tight fit at the head so not sure if it’s going in all the way) or it’s a battery problem.
Thanks everyone!
-
@Zephon said:
My question is that ‘will it work?’ Does can a light powered by a single 10440 be replaced with 3pcs AAA?I tried it but it didn’t light up so I’m trying to see if it’s a physical problem (tube is a tight fit at the head so not sure if it’s going in all the way) or it’s a battery problem.
Thanks everyone!
Yes, it typically can, electrically. A 10440 Li-ion cell is 3.7 volts nominal, 4.2 volts max. AAA cells range from 1.4 volts (NiMH) to 1.8 volts (Lithium). 3xAAA in series would be in the range of 4.2 volts to 5.4 volts, so similar to the voltage of the single Li-Ion cell.
-
@Tasky said:
I understand alkalines are widely disparaged and shunned among the torch fanboy community, being known as alka[i]leaks[i] for obvious reasons.
I actually only have a few torches for which I use alkalines, one being an original E12 because it doesn't take any other, and two being Maglites that I've had since the early 90s and that come with memories. I usually use the el-cheapo multipacks from IKEA, again just because.The original E12 works with Alkaline or NiMH. Much better runtimes and no leakage are achieved with NiMH, and they're cheaper in the long run.
-
@NutSAK said:
The original E12 works with Alkaline or NiMH. Much better runtimes and no leakage are achieved with NiMH, and they're cheaper in the long run.This is true, but NiMH cells are not as commonly found when out and about, and will usually need charging when first purchased... whereas alkaleaks are sold all over the place and are an instant swap-out.
The only way for NiMH to be as viable is if you also have portable charging, such as a car adapter or a solar kit, but this then adds bulk in your load-carrying equipment. -
Thanks for the replies!
I finally made the flashlight work — the extension tube’s top wasn’t making contact with the head’s circuitboard surface (to close the circuit?). In my first 2 attempts, I would stop when it was too tight. What I did this morning was use a Cobra XS and a microfiber towel wrapped on the switch end of the Frog and turned until it stopped, then popped in 3x AAA newly opened alkalines. I got the 2 blinks to show it was working!
Why am I going thru all this effort (and money) for this torch? Well, I want “options”. Alkaline batteries can easily be bought or brought and while having a charger for 1 or more 10440 cells is the ideal scenario, finding a place to charge it (even solar charging) feels more of a hassle than just re-loading new alkalines. It’s more expensive no doubt.
I live in a tropical country where a storm or whatever can cause a power outage for possibly extended periods. Hence, I need options.
Thanks everyone!

-
@Tasky said:
This is true, but NiMH cells are not as commonly found when out and about, and will usually need charging when first purchased... whereas alkaleaks are sold all over the place and are an instant swap-out.
The only way for NiMH to be as viable is if you also have portable charging, such as a car adapter or a solar kit, but this then adds bulk in your load-carrying equipment.My response was simply to your comment that the E12 only works on alkalines, which isn't the case.
What cell you choose to use and why you choose them of course depends on your use case, which differs from mine. I'm never in a position where I need the convenience of purchasing cells when "out and about", so I value quality cells over alkalines. During an extended emergency, I would rather depend on a stash of lithium cells and my ability to find an energy source to charge NiMH and Li-ion cells than a store's ability to keep a high-demand item like AA alkaline in stock.
-
I’ve got a curious question here:
16340 versus 18350
What’s the difference? I noticed that well, on my side of the world, it’s easier to buy a flashlight set with a bundled 16340. The 18350s are usually just ‘an afterthought’ in a light that comes with a 18650 battery. Size-wise, use-wise, cost-wise, is an 18350 worth more than the convenience of a 16340?
It’s just for casual use and not like my life would depend on how long or bright the flashlight would be.
-
The difference is that the 18350 is larger (18mm diameter vs. 16mm diameter) and offers higher stored energy.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login