What did you use your Sak on today?
-
Used a Spirit X knife blade to trim down a champagne bottle cork and get our unfinished Prosecco bottle sealed until tomorrow [emoji898]

-
Wow! You had some left!?

-
Yep, my wife was not really into Prosecco last night, so it was just me for the most part and we have some left for tonight [emoji1738]
One thing I have to note is how easy and comfortable it is to use a blade on a Spirit X - I tried to do this same thing with other knives and this one is just surprisingly good [emoji1303]
-
It’s been a while since I used my favorite SAK - a Work Champ.
Today a water tap has gone loose again in this place we rent during the war and Work Champ pliers grabbed and tightened a hex wrench more than enough to have the tap fixed.
I believe it’s a friendly reminder to never underestimate those seemingly tiny SAK pliers - they can go where my fingers can’t and shouldn’t and they can do what my bare hands can’t and most of the time should not do either [emoji2]

-
Great buddy, stay safe, God bless from all of us in Bronx NYC USA

-
I feel like I’m in a talk show of sorts where you have to fix other people’s home stuff for free [emoji23]
Found two loose handles earlier and got a few minutes to get them fixed today.
Screws pulled using Spirit X pliers - too stiff to be pulled out by hand, then I applied some cool fast-drying epoxy glue and screwed back into place using a ratchet tool


-
Well, this wasn't today so I hope you all will forgive me but....
I flew down to Colorado last week to help my sister and her family. They just moved there from Atlanta and were trying to get their new house set up, etc. Well, I was working with my brother-in-law to run some CAT5 cable around the house and I was up in the attic. We needed to get a mounting plate on the back side of the ceiling drywall to mount a wireless access point.
The attic is very not-finished... no floor (not even plywood laid across the joists) and no lights at all. So I had a small flashlight with me in the attic. This was difficult because I was basically climbing around the rafters up there. A headlamp would have been ideal, but we didn't have one. I got to the place where the mounting plate was supposed to go and realized I needed both hands!
Out comes the Super Tinker! I used the main blade - jammed it into the nearest rafter and looped the flashlight's lanyard over my SAK so I could use both hands AND actually see what I was doing at the the same time. Fortunately, the blade (and tip) was no worse for wear from this experience since the rafters were a relatively soft wood.
-
I've been using my compact for fishing. Scissors for line, the hook is very usefull for pulling hooks (hook for hooks ahah) when tightening knots by the hook.
-
Sadly I don’t have a photo of the knife in action but I stumbled on some beehives and stopped to look and take a picture. Sadly while taking the pic a bee stung me right on my forehead! I used the tweezers of my executive to pull out the stinger, ouch I’ve learned my lesson to keep a respectful distance!
-
We’ve moved to a new apartment - smaller, cleaner, it has an air conditioner, it’s closer to a local gym and it’s 3 times cheaper [emoji471]
But right after I plugged in our router I’ve discovered a pretty much the same issue we had with a previous place - badly installed Ethernet connector.
For some reason here they use only 4-wired Ethernet cables instead of regular 8-wired cat.5 or cat.6 [emoji2371]

It works fine, but looks weird and from my experience I can tell that this connection can get quite unreliable
Anyway, I used my Spirit X Plus to cut the badly installed plug

Then I used my beloved Spirit X wire stripper [emoji1316]

Sadly I still had to use dedicated crimping pliers, but at least I had some joy with the Spirit [emoji1319]
-
At least you seem ok right now!

-
@alexanderre said:
We’ve moved to a new apartment - smaller, cleaner, it has an air conditioner, it’s closer to a local gym and it’s 3 times cheaper [emoji471]But right after I plugged in our router I’ve discovered a pretty much the same issue we had with a previous place - badly installed Ethernet connector.
For some reason here they use only 4-wired Ethernet cables instead of regular 8-wired cat.5 or cat.6 [emoji2371]

It works fine, but looks weird and from my experience I can tell that this connection can get quite unreliable
Anyway, I used my Spirit X Plus to cut the badly installed plug

Then I used my beloved Spirit X wire stripper [emoji1316]

Sadly I still had to use dedicated crimping pliers, but at least I had some joy with the Spirit [emoji1319]
Excellent usage and glad things are looking up

Stay safe out there

-
Went to the pub with a mate yesterday (Friday) and whilst attempting to hang my jacket I noticed the hook under the bar counter was loose.
Climber's Phillips/Small screwdriver to the rescue


-
New place - new challenges [emoji23]
Today started bright and early - at 6:30 AM to be precise - I woke up to some conversations that seemingly happened right next to our bed in our room [emoji848] After a few moments of careful listening I found a hole in the floor with a piece of a badly cut tube in it and I even could see our neighbor’s place through it. That’s how I could hear their radio or TV loud and clear for the entire night [emoji15]

No action shots, but I used my LM Wave’s saw to trim the excess tube and stuffed a hole with cotton - we’ll see if it’ll work tonight .
Later I’ve found a similar hole in the kitchen. But anyway.
This place may become a tad better for sleeping after I patched that hole, but it totally sucks as a workplace, which is a must for us at the moment. So I’ve found that Jysk has some cool tables at 50% discount, found one I liked and brought it home. Spirit X Plus took care of the rest. And my god I’m grateful for having at - I used quite a few tools during the assembly and the ratchet is absolutely priceless [emoji1316]
Here’s the end result:

Here are some action shots:
Spoiler:






Having assembled the new table I’ve also tightened a chair I’m about to use - it went way too loose for comfort, but I managed this in no time at all


And even cut some tomatoes and mozzarella for dinner [emoji899]

-
New day - new use [emoji1316]

-
Nice-looking tea kettle, too!

-
Possibly the nicest cider I have ever had.
[attach id=0 msg=2352506]
-
The Airbnb we’re staying at has a garage which we’ve been stringing up wet swimsuits and towels in. This morning the door into the garage wouldn’t open, potentially ruining our planned day at the beach! Luckily I had my Swisstool Spirit X on my belt and was able to disassemble the doorknob. Then I used the pliers to actuate the door latch from within, winning us the garage back. I didn’t take any photos during the process but got one afterwards.

-
MB scaled SwissChamp helping with car maintenance:
A drop of oil for weekend dash for the Benz:

And splash of coolant for the Chevy after working hard thru recent heatwave:

Sent from my iPhone using Tapatalk
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login