Broken Crunch
-
I’ve posted in the Mod forum, but it might be better here - my Crunch is poorly.
The pin that holds the lock plate in place has fallen out, and although I can get it back in, it’s loose and will just come out again.
I know I could send it in for warranty replacement, but it’s an oldie, a ‘99, and it feels like I should try to keep it alive.
Has anyone ever had this happen, and either found a way to secure the pin again, or a way to modify it into a non-locking tool?[attach id=0 msg=2368459]
[attach id=1 msg=2368459]


-
That stinks! I have a Crunch, but it is at home and I cannot look at it, but does the other end of the pin look like a small screw went into it? If so, maybe one from another tool or knife would fit into it. I am also thinking that Leatherman may sell parts for these tools. A replacement pin and screw (or whatever was in the other end!) could not cost a whole lot! Maybe somebody else more knowledgeable than myself will respond here!
-
That is cruddy, Crunchie :-\ :ahhh
I looked at one of mine and the pin looks like that

Perhaps after getting it in you can take a hammer and something that wouldn't Mar the metal and give it a few good whacks
to tighten it back up
:D -
I had to push that pin back into place on my Crunch as well when it was new. It is holding up fine since though

-
I’m not sure I’ve got the skills to fix it, so I think it’s probably going to go back for warranty replacement.
I just can’t work out what’s gone wrong :-( -
@Crunchie64 said:
I’m not sure I’ve got the skills to fix it, so I think it’s probably going to go back for warranty replacement.
I just can’t work out what’s gone wrong :-(mark it as sentimental and you'll get it back fixed or not.
I had a surge I sent in missing the tool lock and they did not replace it, they replaced only the tool lock. i'm betting, unless there is something wrong with the frame. that you get it back.edit, interesting, i did not recognize the knurled pin you had there and pulled my newer 08/20 crunch and it does not have the knurled end. maybe measure the pin and go up a few thousands or tenths of a mm and buy some brass rod. that shouldn't damage the steel and you should be able to drive it with a light hammer.
-
@Crunchie64 said:
I’m not sure I’ve got the skills to fix it, so I think it’s probably going to go back for warranty replacement.
I just can’t work out what’s gone wrong :-(so what is the update? did you push the pin back in and tappy tap tap or send it in?
-
I pushed the pin back in and stuck it in a drawer.
I’ve got another, newer Crunch that I’ve been carrying instead. Can’t decide if I want to keep the old one just because of its age, or send it in for warranty exchange.
-
McStitchy said putting it back once all he had to do. don't let it get past it's 25th without using it and seeing if it needs to be fixed.
-
Maybe you can put the pin in from the other side and see if it fits better that way. Sometimes pins have a slight taper to them and only fit tight if put in from one side. Otherwise I would take something like a hardened punch and try to flare the ends just a little bit with a couple of good hits.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login