84 mm Golfer restoration
-
So far, so good. I intentionally stayed outside the line I scribed on the curve next to the keyring to make sure I could actually keep that clean. The next step is to get it even with the keyring and do the cutout to open the nail file. I'm also waiting for 1.7 mm brass for the nail file pivot. But for now I need to take the vise off the dinner table and clean up for the workweek. :P


-
Looking Good

-
Looking good. -
I’d hate to see the box that damaged that blade!
I was actually expecting it to be burnt from a live wire, but I’ve damaged my fair share of knives in surprising ways. Looks as if you’ve planned this well. Can’t wait to see it when it’s fully restored. -
Mod. 0.3422

-
It's coming along quite nicely. As badly as that blade was damaged, it's somewhat surprising that the LNF remained intact.
-
Nice work, proletenstahl - hope the rest of the work proceeds smoothly!

-
COVID put everything on hold and then some urgent things took priority. The parts have been sitting under a dust cover for two months! :'(
I did get some more details from Victorinox, though:
"Both numbers 0.1622 and 0.3422 are correct - there was a change of article number around 1984 and so the 0.1622 became 0.3422.
So there is absolutely no difference.
We could find this model in the catalogues from 1977 until 1999."
If no one has any info that conflicts, I can add those dates to the wiki. -
Very nice project, @proletenstahl! Good call on using a Waiter as a donor knife, too. Re-profiled blades always look so wrong to me... I understand having to do it in cases where the knife is rare, but with modern SAKs there's always a good chance at finding a donor that is correct right down to the tang stamps.
I have a LNF Golfer around here somewhere too. I'll have to dig it out.
Myron
-
I got the cutout for the nail file nail nick done, drilled the holes for the nail file pin, and filed the middle liner down to match the key ring.
Everything snaps nicely! I still need to bevel the nail file pin holes and the hole in the middle liner for the pin that doesn't go all the way through.



-
I couldn't find any 1.7 mm brass pin stock for sale, so I wound up buying a parts kit for an air brush that claims to be brass. We'll see how it peens!


-
Hopefully it'll peen nicely. You've done a great job thus far!

-
Great updates. Keep posting!
-
I managed to match the bevel on the inner hole for the two pins that don't go all the way through the knife.




-
I had to start with the middle liner to accommodate the pins that don't got all the way through.




-
I forgot to mention that I used the corkscrew pin from a 91 mm three-layer junk knife.




-
I used another blade/combo tool back spring as a back stop to hammer the nail file pin without driving it through or bending the liners.




-
If you already noticed how close the nail file pivot hole is to the key ring, you're smarter than I am. >:(
I used the back spring again so as not to drive the short pin through to where it would jam the scissors.




-
Now we just need some scales. The split ring does fit, but you have to open the nail file carefully and it puts some sideways pressure on the file as it squeezes past.



Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
