New love for the Pocketwrench II
-
Thanks Poncho

-
Poncho ...and what a beautiful pic 
-
Thanks Stitchy

-
Has anyone tried the LM Ratchet Driver in the PocketWrench II? I have been looking at upgrading from a simple 1/4" extension to hold bits in my PWII to it to make the tougher jobs easier.
-

You will need to devise a spacer to keep the PWII from sliding too far down the shaft of the ratchet.
-
A massive shout-out to McStitchy

[attach id=0 msg=2390958]

-
:D

I also found a tool from Japan (made in Taiwan) that looks lime a cross between the PW and the Piranha:

-
Awesome collection, Adam :o
-
-

I also found a tool from Japan (made in Taiwan) that looks lime a cross between the PW and the Piranha:

Nice collection indeed

That packaging and the clearance sticker is interesting. Were they 1.99$ originally?
Did no-one want to buy them?
What's the story about the Pocket Wrench trad° ?
Is it any good?
Oh, and you need a stainless USA Latshaw still ?
-
@McStitchy said:
Nice collection indeed
Thanks, pal

That packaging and the clearance sticker is interesting. Were the 1.99$ originally?
Did no-one want to buy them?
Perhaps they were being made in Taiwan cheap enough to be sold for $1.99?

I doubt the PWs made in the US sold that low.
And I don't know why no one wanted to buy them, but I feel that I myself would not have appreciated the PW II's utility 10 years ago. I know better now after using one.What's the story about the Pocket Wrench trad° ?
Is it any good?
The tradR Pocket Wrench is sold by Misumi. It is showing as unavailable on the UK site and is temporarily unavailable on the US site. I might be lucky that I was able to order one.
Then again, it came in just this week, and I have not had a chance to try it out. So, it may not very good. I can tell that the ridges or teeth are smoother than the PW II CV and are more like the Taiwan version. If it can grip nuts well enough, it should be able to handle a wider range of nut sizes and situations. On the minus side, it can't be used as a prybar or a screwdriver.
Oh, and you need a stainless USA Latshaw still ?
Yes, that is the main version that I am missing. I have missed out on two of them on eBay so far >:( , but I think I can snag one eventually.
-
Congrats nakken 8) good on Stitchy for the help

The collection you have going looks awesome, Adam :o

-
Adam,The Misumi one is interesting. Are you going to try it out on a few nuts?

-
I will try it out tomorrow

-
I found that it worked well.
It could tighten this 5/16" bolt:

After I had started this 5/16" drive screw by other means, I was able to screw it into the wood 1" deep with no problem, and there was no problem with backing it out:

I was also able to torque down and loosen this 1/2" bolt:

Also, the trapezoidal hole in the middle will firmly engage with a 1/4" bit driver:

I think it is a solid wrench

-
Wow... there you go. Awesome... thanks

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
