Red Alox
-
Old crosses [attach id=0 msg=2409081] p

-
Nice SAKs
and good resurrection of a necro thread

-

As you can tell from my avatar, I have a soft spot for the old cross!

And I like the engraving on that lumberjack blade, really cool!

-
So many great photos here.
Here is one of mine. Not the best photo but it is on the job site being used so I have to get some points for that right?

-
@HarleyXJGuy said:
So many great photos here.Here is one of mine. Not the best photo but it is on the job site being used so I have to get some points for that right?

Heck yeah!

-
1961 Soldier
OC Pioneer
OC Farmer
New Farmer XI hadn't really lodged in my mind that I had four red Alox until I read this thread.

-
My only one...so far
![rNAGgeX[1].jpg](/assets/uploads/_imported_attachments/migrated/551828_rNAGgeX%5B1%5D.jpg)
-
@HarleyXJGuy said:
Excellent………..Start.
Exactly!
-
@gustophersmob said:
How about some red alox?L-R:
2018 berry red classic
2018 berry red cadet
2018 berry red pioneer
1985 dated old cross pioneer
~2008 red farmer 1
~2008 red farmer 2I’m really digging the cadet, pioneer and farmer that are missing the key ring nubs

Did you remove them or did they come like that?
-
Very nice guys

-
@Explorer said:
I’m really digging the cadet, pioneer and farmer that are missing the key ring nubs
Did you remove them or did they come like that?
I removed them. Basically any alox I carry I grind them off.
Funny you should mention it as 15 minutes ago I finally decided to remove the key ring from my one remaining old cross pioneer.

-

Beautiful pic!
-
@gustophersmob said:
Beautiful pic!

Such a beautiful place!So Gusto do you have a specific way that you remove the key ring nubs? I’ve been thinking of removing them from my farmer and farmer x. My approach was going to be cut off as much as I can with some metal shears and then file the rest down with a Dremel. I’m curious since you’ve done so many perhaps you have a better way of approaching this.

-
Yeah, here’s my process:
- I remove as much as I can with some diagonal cutters
- I tape off around the remaining nub with one layer of electrical tape.
- I use a small, variable speed, hobby bench grinder from harbor freight and on a higher speed remove as much material down to the tape as I can (need a steady hand)
- I remove the tape and slow the speed of the grinder way down and slowly get it as flush as I can. This is the most nerve wracking part. I’ve not found a way to get it flush while protecting the scales as even a few thousandths of an in thick of tape leaves a noticeable bit of the nub when removed
- finally I use a needle file to nock down the edge and smooth out the grind lines.
The key to it all is slow and steady.
-
Thanks mate! much appreciated

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

