Clipdraw McGraw
-
I'm gonna bet that I buy one of these soon.
-
I'm gonna try it on the Spirit and if it goes well, I'm gonna see if it'll work with a Juice. :ahhh
-
@Mr. Whippy said:
I'm gonna try it on the Spirit and if it goes well, I'm gonna see if it'll work with a Juice. :ahhhThe backplate is 3" long so all you need is a smooth surface of at least 3".
-
I wonder if it would still work with the sticky part limited/cut to just what's under the screws or so... :-\
-
@Mr. Whippy said:
I'm gonna try it on the Spirit and if it goes well, I'm gonna see if it'll work with a Juice. :ahhh
The backplate is 3" long so all you need is a smooth surface of at least 3".
It looks like 1/4 inch or so could be removed from the backplate, true?
-
@Mr. Whippy said:
@Mr. Whippy said:
I'm gonna try it on the Spirit and if it goes well, I'm gonna see if it'll work with a Juice. :ahhh
The backplate is 3" long so all you need is a smooth surface of at least 3".
It looks like 1/4 inch or so could be removed from the backplate, true?
The sticky strip sticks out past the end about 1/8" or so. I just trimmed it off to flush with the backplate. Width wise it is barely visible but could be trimmed with a razor blade to eliminate any overlap.
-
@Mr. Whippy said:
@Mr. Whippy said:
I'm gonna try it on the Spirit and if it goes well, I'm gonna see if it'll work with a Juice. :ahhh
The backplate is 3" long so all you need is a smooth surface of at least 3".
It looks like 1/4 inch or so could be removed from the backplate, true?
The sticky strip sticks out past the end about 1/8" or so. I just trimmed it off to flush with the backplate. Width wise it is barely visible but could be trimmed with a razor blade to eliminate any overlap.
Check your email. ;)
-
MY REVIEW BECAME A SOSAK ARTICLE!!!
I had no idea!! I'm so pleased! :D :D :D
BTW, clip is holding fine. No signs of weakness and i've been using it every day :)
Sorry for gratuitous use of smileys, I'm beside myself :D
-
Also, just a point to note, the surface you paste the tape on doesn't have to be completely flat. As mentioned in the review, it will stick fine even if you run it over the rivet. I don't have a full Swisstool, but if the rivets are the same as the Spirit's, I'm sure you can do the same there.
And regarding the backplate, yes, it's longer than the clip itself. But I think that's so the tape gets more gripping surface. Those who have the means to cut the baseplate perhaps can try shortening it, though I think the total hold won't be as strong if you do.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
