Power Access Owners BEWARE
-
The blade in mine just had the same failure. I was cutting some thick cardboard, when suddenly the blade gave away backbards like in Def’s pics. :(
-
This seems to be a significant and widespread issue.
SOG really ought to be responding to this
-
i contacted the warranty dept via email this morning, and mentioned similar issues appearing to be widespread. the customer service rep responded a few hours later, asked me to send mine in for repairs, and said that they had not received much if any similar negative feedback. so i sent him a link to this thread. hopefully they will address the issue.
-
Sounds like the need a revision 2 on this design. Looks like people really like it (I had my eye on it too). But it seems like it's a design/functionality oversight. Bummer. Definitley has that cool factor

-
i didn't send mine in for warranty until just this week, but notice one more crappy thing about it before sending it off: the pocket clip comes loose and falls off nearly every day. it you tighten it enough to prevent this from happening, the pliers won't open. i really hate to resort to using locktite.
we'll see what they do about all of the flaws.
-
I haven't had that problem myself. My Power Access has a fair few miles on it now and the pocket clip is still rock solid.
I hope they get it sorted out for you ASAP!
Def
-
@Grant Lamontagne said:
I haven't had that problem myself. My Power Access has a fair few miles on it now and the pocket clip is still rock solid.I hope they get it sorted out for you ASAP!
Def
I haven't even had the lock slippage issue on mine. It does seem super common though. I must be one of the lucky few.
-
Got my poweraccess in today. Upon checking it out, I immediately noticed the problem Grant had, but with the phillips driver. The lock tab didn't sit inside the tool's back groove very well and the phillips just went backwards. I took a needle file to the top of the groove notch and remedied the issue without any disassembly. But, it should have never left the factory like that. I'll post a photo in a bit with the quick fix.
-
First photo shows the tab bypassing the tang notch. Needle file took a miniscule amount of metal from the edge to open the notch a tad. Now it sits perfectly. I will do this to all of the tools on this poweraccess. Hope this saves some people return shipping on their poweraccess.
This is not an issue with the locking system in my opinion, but a QC issue.
SOG SOG SOG.



-
I’m gonna zombie up this thread since I also zombied up this tool up from 2017.
I had extra time yesterday afternoon and took apart the PowerAccess to test a theory I had.
The red circle in the picture shows how I slightly bent the ‘lock spring’ counter to the unlocking direction. I made sure not to bend it too much so the metal won’t break.
The red rectangle is where I shaved off some metal using a ST300’s metal file. The lock is not practically flush with the frame. Not sure if it matters.
My problem is now with the large/r flathead. It still folds on itself but not as easily as before. I moved it to the far end across the knife and didn’t place a washer between it and the frame.
Hopefully this makes the tool a bit more……useable and won’t cause picture #3 to happen.



Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login




