Stripped screw on multitool
-
I'd start with the right tool. You might need to wrap it in a layer of aluminum foil to fit tight.
These usually have locktite on the threads so a little heat might be needed as well. -
I wonder how LM warranty would treat that.
-
Welcome to
I would do as stated above by smiller first with the heat and aluminum foil
if that doesn't work then we can try to figure out something else 
-
-
Failing all tithe above you could cut a slot in it with a Dremel and then use a flat driver.
If you have a welder you can also weld another bit onto it and turn that, or using a drill press drill it out.
-
You could always just say, "Well I buggered this one up" and use it anyway. Tools are tools to me. Banged up doesn't really bother me. Even if you get the screw out, you don't have a replacement, right? There is no reason to think any repair you make will be satisfactory or look good either.
A factory repair sounds good to me. I would see how much they would charge, or just say to heck with it and use it as is. Best wishes G -
@IMR4198 said:
You could always just say, "Well I buggered this one up" and use it anyway. Tools are tools to me. Banged up doesn't really bother me. Even if you get the screw out, you don't have a replacement, right? There is no reason to think any repair you make will be satisfactory or look good either.
A factory repair sounds good to me. I would see how much they would charge, or just say to heck with it and use it as is. Best wishes GThe last time I spoke to Leatherman about this (which admittedly was a while ago, they had nothing set up to charge people for repairs. I think they just use the warranty service for pretty much anything.
Def
-
Ironic, isn't it?
Isn't this nearly the same thing as us using a multi tool? "Not quite the perfect or right tool for the job." Some times it buggers up the job. 
The Multi Tool truly defined... a jack of all trades, master of none.
Don't torch me... I carry and use one every day.

I do truly feel for the op. I've done this exact thing several times. You'd think I'd learn.

-
@DIAMOND said:
Ironic, isn't it?
Isn't this nearly the same thing as us using a multi tool? "Not quite the perfect or right tool for the job." Some times it buggers up the job. 
The Multi Tool truly defined... a jack of all trades, master of none.
Don't torch me... I carry and use one every day.

I do truly feel for the op. I've done this exact thing several times. You'd think I'd learn.

The full phrase is **“a jack of all trades is a master of none, but oftentimes better than a master of one.” **
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login




