Combo tool mods
-
I really have a problem with the combo tool, as it is, but finally got brave enough to mod a couple to better fit Philips screws. Here are some pics…
Bantam and Compact. Bantam ground on top of the combo tool, and Compact on the bottom…

They both work very well.



One thing, though; if you do the bottom grind, you have to slightly angle it like this next pic, so it can bite the starter hole in the can better. I hope you can tell here…

So nice to be able to screw in a Philips straight on, not angled.
-
Nice work, and you can still open a bottle of beer after all that thirsty Phillips un/screwing!

-
The bottom ground off section on the combo tool is how they used to be. I like your mod. This is the combo from my well-worn Vic Trooper (GAK). Someone made a post about the combo tool changes in Victorinox. Don't know who it was. Good work on your mod. Best wishes. Gary

[attach id=0 msg=2441119]
-
Thanks for the closeup pic of that. It's pretty cool.
-
@Jazz said:
One thing, though; if you do the bottom grind, you have to slightly angle it like this next pic, so it can bite the starter hole in the can better. I hope you can tell here…So nice to be able to screw in a Philips straight on, not angled.
It's a nice mod that can add a bit more functionality to the (almost useless, for me) Combo tool, even if it's still quite fragile.
I'll probably try it
Are you able to give an approximation of the two measurements of the cut, indicated below, please? :D

-
I’m totally going to do that in future. Great mod.
-
Brilliant - Thanks for sharing
-
Thanks. I forgot to try and measure today. Sorry. I just grind on a sharpening stone at approximately that angle a bit at a time. Test in a Philips screw after every bit. When it fits nicely, you’re done. Make sure of the side slanted angle, so it still can puncture a can though. Smooth off any burrs after, also. Easy.
-
Just doing an eyeball measurement, it looks like the length of the bottom grind and the remaining original screwdriver surface are about equal. More or less. Shouldn't be too hard to duplicate. The angle on the grind would be important as he keeps saying. It needs to have a little wedge to it to better pierce a can top. If it is 90 degrees, then punching through would be hard. I have used the combo quite a bit through the years on cans. That first cut through the can top is important. Best wishes. G
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login