Show Us Your EDC gear!!!
-
@chip said:
You buy coffee in cups that say caution contents hot.In the past I have bought a medium sized strong plastic toolbox, that was clearly designed as a handy step due to the fact it had legs, a chequer plate design on the lid apart from the Center where it had two foot prints.
But on the side it said CAUTION: do not stand on the box 😂I have also bought a full size corded power drill in the past that warned not to be used for dentistry in the small print of the instructions.
Well, since this is a tool forum:

??? ??? ??? ???
-
erm, i can't believe they had to put that in writing
-
Today's "stuff"

-
Is that a fried egg challenge coin or a memento?
-
@AzteCypher said:
Is that a fried egg challenge coin or a memento?It's from the Breakfast Club EDC Facebook group
-
Great items MTSAK.
-

Sent from my iPhone using Tapatalk
-
I like them scales colt.
That's a neat pry tool Heywood. I like the pattern. Which one is that one as I'm not familiar with it.
-
@AzteCypher said:
I like them scales colt.That's a neat pry tool Heywood. I like the pattern. Which one is that one as I'm not familiar with it.
Hey AC, its a JDR Knife & Tool Hammerhead - Chad Nichols' Lizard stainless Damascus steel
-
Me, every time I do this: That’s a lot of stuff. I need to cut back.
Also me: But I use it all…
Not shown: House & car keys, cell phone

-
@pfrsantos said:
That Leroy Merlin card, did you cut it to hold the OPT or is it a thing you can get from their store?

It's an in house hatchet job …

Peter Atwood G5 Prybaby - CPM S35VN
Victorinox Swisscard Lite quad flat screwdriver
MBI Matchbook match - Water Resistant LED (match head) with lithium battery & magnetic end section. Activated ON/OFF by moving head IN/OUT
Placed in cut credit card (retail hardware loyalty program)
Held in place with a few thin strands of sticky tape

-
Wow, nicely done! You could make the same inserts for the Quattro and the light, it would make the card thinner. That's a great way to carry thin but oddly shaped items in your pocket.
Thanks for sharing!

-
@pfrsantos said:
Wow, nicely done! You could make the same inserts for the Quattro and the light, it would make the card thinner. That's a great way to carry thin but oddly shaped items in your pocket.Thanks for sharing!

Thanks.
I tried cutting a card to carry the Vic Quattro with Atwood but it made the card too flimsy so went with plan B. If flimsy, the card is harder to remove and reinsert into the wallet.
It probably could be done with some better polymer and laser cut pattern. That is, so it would be more rigid. Manual cutting tends to leave some residual stress that distorts.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


