Swiss+Tech carry
-
High winds yesterday. I heard a tree go down on the property, but didn't see where. When it warms a little (and the sun comes up) I will have to walk down the driveway and look things over.
This was Swiss+Tech with some yard tools. Might need different tools today. Birds are singing. Electricity is still on. I felt like eating a little breakfast. Could be worse. Best wishes. G
;) DAY 7
[attach id=0 msg=2469983]
-
My outlaws had tornado force winds in their area with softball sized hail. By some miracle they were spared most of the wind and only experienced pea sized hail. Folks to the west of them got hit real hard. Lots of cars were totaled. The biggest event in their area was a large water oak that fell on the road.
Glad you still had electricity. I'm always up for a bit of breakfast. I never mind some grits or some biscuits and gravy.
-
Got industrious and decided to saw and lop yesterday. The cold wind whistled through my clothes and froze my goofy grin. I think I will let it warm up some more.
My pole cutter looked a little dull and so I used my utility two-sided carborundum for sharpening and a block of wood to tap out the bolts. Swiss+Tech handled the nut loosening and tightening. The handles/screwdrivers don't lock on this tool, so they try to swivel out of line when you are using the pliers. Annoying, but I decided to use just this tool instead of going back for any more efficient tools. It all worked out. Folded the Swiss+Tech and put it back in my pocket.
Some cheapie tools are so soft that the screwdrivers or other parts are damaged when you use them. The Swiss+Tech hasn't shown any damage so far. The screwdriver pivots might be a little looser than before. Indeed the rivets holding the screwdriver/handles are probably the weak point of this tool. It is really a fairly light duty tool. I have actually used every tool on this thing for around the house work. Shears, wire cutter, pliers, both screwdrivers. So far I haven't used the measuring marks for anything.
If you might need some small pliers or some screwdrivers for carrying, along with your usual pocket knife, one of the Swiss+Tech tools might work for you. It is less capable than a full size multi for sure, but small size does have its advantages. I know the same company makes some other types of knife based multis, but don't have any experience with them. I saw one on the net that looked like a Leatherman T4, or whatever they are called. Might be okay.
:) DAY 8
[attach id=0 msg=2470141]
-
Another trip to shopping center. I was a little more careful with Swiss+Tech this time. Looks like the lot is empty. I just parked a long way from the store. Lots of people packed into the generic Chinese restaurant. There is a new Jersey Mike's sub shop in the same area, but it never has opened. Looks finished, just not open. I think everybody goes to Chick-Fil-A anyway. I haven't been in a fast food joint in years.
I carried the little tool, but didn't use it. Might work outside if the wind doesn't kick up. Best wishes. G
;) DAY 9 [attach id=0 msg=2470289]
-
Swiss+Tech went along on a trip to the dumpsters with a follow-up to a coin laundry. There is a photo offered as evidence of course.
:D DAY 10
[attach id=0 msg=2470450]
I have received a couple of personal messages from one of our members about his family. It seems after a certain photo event with a hobo knife and a pizza, that the wife has seen the value in the hobo knife. Indeed she took possession of the implement for herself and left instructions that similar instruments should be procured for the children. That started me thinking of some of my past inventions.
First there was the do-it-yourself SwissChamp. That's the red one in the photo. It has received some favorable notice here. Then, there is my homemade Leatherman Leap which was a FoBe Opinel award winner. That is it in blue. Easily convertible to black and maybe to red if I could find my red masking tape. Then I got an idea.... how about a hobo knife?
[attach id=1 msg=2470450]
And here it is. The hobo multi tool. All parts easily obtainable. The spoon is readily available in any soup kitchen when the server isn't looking. The knife also. You see that this one has been sharpened and reshaped from an old GI kitchen knife. Much more useful in the hobo camp that way. That is a P38 can opener twist tied to the primary module. The pencil is used for doing crossword puzzles and ear cleaner. Spoon doubles as an excellent back scratcher. All wraps up nice and tidy in a newspaper. [attach id=2 msg=2470450]


-
I put out some supper for the roaming critters last night. First guest was a large black cat. It took one little sniff at the simulated mashed potatoes and dry packaged turkey dressing and turned up its little black nose. Much too well fed for such provender. Now I know where all my bad luck had come from lately. The 'bad luck' will wish it had stayed home as soon as the local coyote pack zeroes in.
Several raccoons and possums were less particular. Then a gray fox showed up. First one I have caught in a camera in two years or so. Used to be common visitors. Not anymore. Best wishes. G
[attach id=0 msg=2470455].jpg)
-
I like your hobo idea, LOL!
-
More multitools should have writing implements. I've started trying to slap plus scales onto as many of my SAKs as I can whenever I can find them for cheap.
Any chance of a DIY Swisstech?
-
I looked at a YT review for a Swiss+Tech plier based multi-tool. Might not still be available. Last time I looked at the Swiss+Tech website I saw some knives, but no multis of any kind. Evidently, they sell lights and power banks and other sorts of things through W-Mart.
I just happened to run across the Swiss+Tech I have now by accident. It's primary allure was the $2 price tag. When I first got it, I used it to hook up some 300 Ohm twin lead to an antenna. I also tightened some screws with it around the house. After carrying it on a keychain for a while, I decided the weight was greater than the utility. That was how it got relegated to the first aid kit in my waist pack.
I rarely carry a writing instrument now. When I carried a pen, I generally used any ball point that would write. Generally something I found somewhere or got from the bank. I always have something to write with in the vehicles.
Here is a better shot of the home-made utility knife. It was in a cigar box of punches, drifts, wood bits and other junk. There was also a rusty square ended carpet knife. $1 for the box. Best wishes. G
[attach id=0 msg=2470471]
-
@IMR4198 said:
I put out some supper for the roaming critters last night. First guest was a large black cat. It took one little sniff at the simulated mashed potatoes and dry packaged turkey dressing and turned up its little black nose. Much too well fed for such provender. Now I know where all my bad luck had come from lately. The 'bad luck' will wish it had stayed home as soon as the local coyote pack zeroes in.
Several raccoons and possums were less particular. Then a gray fox showed up. First one I have caught in a camera in two years or so. Used to be common visitors. Not anymore. Best wishes. G
[attach id=0 msg=2470455]Well, since that's a black and white cam, a grey fox is the only type you could get on film...

-
I tried to use Swiss+Tech to help fix the last working clock in the house. It actually still worked. At least the minute hand did. Screwdriver was too stubby. Somehow I managed to fix it anyway. That is a drawback to the tool. The flat bit has too much taper. It is more like a chisel. If it fits the screw for width, then just the very tip will engage. Too thick to fit to the bottom of a screw slot.
I did tighten some screws on various things around the house. Doors and such. The screwdrivers were adequate for that. Doorknobs are difficult becase the tool can get blocked out before the screw can be reached. Generally I could fold the Swiss+Tech so that the screwdriver was working at 90 degrees. The Phillips driver worked as well, but it fairly large. Not much good for smaller screws. There is generally enough grip area to move a fairly tight screw, but it would probably be possible to wreck the screwdriver pivots.
I might as well post a photo of using a slot driver to adjust a screw. Best wishes. G
:) DAY 11
[attach id=0 msg=2470570]
Yard work yesterday until the rain started. Saw mostly. I clipped a Leatherman to my belt pack but lost the thing before I starting working. Noticed as I was dragging away tree limbs that the Leatherman was gone. Walked back over where I had been and found it under a tree. I hate the clips on the sides of knives and multis. G
-
Does everyone get the same ads as me when you go to MTo? Every day lately I have gotten some sort of tease with the line "Dana Delaney, 67, leaves nothing to the imagination." Dana used to be cute, and might even be a cute 67 year old, but I don't need to see her biological external mechanisms.
Digital pimps notwithstanding, it might be time for a Swiss+Tech post. You have already viewed this Chinese cutie with nothing on. Not even a coat of oil. I am not sure if this thing is plated with something, but I will say it never has rusted yet. The little keychain tool was used to straighten the tip on the not so cute revamped table knife from a previous post. You can easily see the bend in the original photo. Swiss+Tech straightened the metal right out. I must have sharpened the edge sometime in the past. It cuts paper rather well.
I haven't put enough pressure on the little mini multi yet to loosen it up. The center pivot for the pliers is the same sort of rivet that holds on the screwdriver 'legs'. Just bigger in diameter. Will I continue carrying the multi once this yawn provoking series of posts is finished? Hmmm?
Best wishes. G
;) DAY 12 [attach id=0 msg=2470729]
-
The evil computer somewhere in an underground cavern finally decided that I wasn't going to bite on the Dana Delaney cheesecake. So, a bunch of semi-conductors got together and decided to tempt me with a newer model. Now it is Demi Moore, 61, Leaves Nothing to the Imagination. Hmmm? No. Don't need to see Demi Moore's upholstery either.
Swiss+Tech did some plier work. The small pliers are okay for adjusting jam nuts and tightening knurled pieces. I saw where some models came with the screwdriver 'legs' swiss cheesed to lighten them. They should all have been done that way. The little tool has high utility for something so small, but in spite of its small footprint it is fairly chunky. Best wishes. G
;) DAY 13 [attach id=0 msg=2470842].jpg)
-
I liked my little SwissTech but the pivots loosed up in mine and it was never the same. I tried re-peening them but to no avail.
-
I can easily see how putting a lot of stress on the tool would loosen things up. The screwdrivers were described by the Swiss+Tech outfit as both being No. 2 drivers. The rivets are definitely a little on the small side especially for trying to turn out a tight, rather large screw.
This little multi is in a different league quality wise than the laughable Chinese camp knife that I carried last time out. With that said, it could have been improved. Best wishes. G
:) -
Almost finished with this 15 day thing. I have a halfway decent photo of a pocket dump. The battered Casio watch wasn't exactly in my pocket. But it got in for the snap anyway. I always carry a folded paper towel as well. You might see a corner under the wallet. It looks just like a folded paper towel in case you are curious. Swiss+Tech is there.
So far I have lost the Swiss+Tech once, and a Leatherman Wingman once. Both last week. I didn't think I would need a tether, man for my Leather, man. But I might be wrong, man. Most of these multi-tools are slippery. Might need to find some grippy tape for them, or maybe slop some kind of rubber coating on the outside.
I didn't get a photo tease with Dana or Demi yesterday. Just one for Michael J. Fox. There was a photo and a statement that he was 61 and living alone in Tennessee. I hope that wasn't a plea for a roommate. At least there wasn't something about photos 'Leaving Nothing to the Imagination'. I asked whether anyone else was getting these kinds of ads on MTo, but nobody answered. Here is how my imagination runs. Overage star scuffs through the kitchen with tatty pink fuzzy slippers without lifting her feet. Says, "Coffee". Then a swear word. "Smurf".
I ask, "Breakfast?". She says, "Don't start with me".
Best wishes. G
;) DAY 14 [attach id=0 msg=2470953]
-

I'm seeing fishing and hotel advertisements.
-
Swiss+Tech will probably be put away after today. If you are interested in the history of these tools or the company, there are lots of interesting things to read here on MTo. Chako did a series of posts about them under the Cheap but Cheerful board. Hiraboo did some under the Collector's Corner. There should be plenty of used ones out there if you decide you want one.
I might as well show a photo of Swiss+Tech taking it easy sitting in the sun. Next to a drink and a cutie in a swimsuit. The bathing beauty is the one on the old Seven-Up bottle. There is a little branch that runs down beside my house. It is the location of choice for all the thirsty critters in this locale. After a hard rain, it floods out in one corner of the yard. Sometimes it washes down some old relic from somewhere. I never have discovered where. Once I found an old Coca Cola bottle that had been discontinued before WWI. This Seven-Up bottle was dredged up the same way. Lots of print on the rear of it. Raised yellow lettering. It has an Asheville, NC address. About 70 miles from me. The date on the bottom is 1941.
Demi and Dana have gone away it seems. I probably didn't pay them enough attention. Thanks to all who have followed along. Best wishes. G
DAY 15
[attach id=0 msg=2471097] [attach id=1 msg=2471097]

-
Did you keep any of the other stuff that turned up? I
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login