What did you use your Leatherman for today?
-
Window broken by falling branch during yesterday’s wind. Well replace the window once it’s warmer outside. For now it’s board up with some insulation.
Used modded Wave to cut the board and hold nails.
[attach id=0 msg=2454532]
[attach id=1 msg=2454532]
Now for a beer. It’s a great can opener but terrible cap lifter
[attach id=2 msg=2454532]



-
Today i used Rebar for fixing my car (again) noticed also that Wingman flathead can be used on sockets, offcourse i dont recommend using it for too tight screws.


Only Tools Matters
-
Great pics and use, Antti 8)

-
I have been using my Rebar at work constantly lately. Demoing a construction site I used the Rebar to cut wire, remove wall plates, cut ceiling ties. I have been really impressed with how tough the Rebar is.

-
January has been all about unpacking and installing shiny new screens, projectors and such. It's not exactly what they pay me for but I don't mind! Skeletool, bitkit and headlamp see a lot of use.
-
Until there’s a replacement for the Hybrid, the Raptor is my favourite gardening Leatherman.
Hacking at some ivy while the sun was shining today.
[attach id=0 msg=2470019]

-
I don't take many pictures, but I think there isn't a day the LM doesn't see at least a little bit of work.
Yesterday was helping a friend move, he had no tools available, I broke down a table in 10 seconds. When he saw the smallish looking PST he said : "it won't work". Than stood corrected. I might get him one one of these days.If he recognizes how wrong he was. :D
-
Needed to do some work on my ancient Echo weedwacker. Pulled a bolt on the bottom gear housing and put in some grease. Then a cleanup of the air filter and housing. Leatherman Bolster did the work. Spark plug is rusty, but it started first pull and ran perfectly. No reason for a new sparkle.
The newly hatched out paper wasps all swarmed around and checked out the action. I don't think they had ever seen a man get grease over so many different things and drop parts in the dirt so many times. If they laughed it was too high for human ears. Best wishes. G
:D [attach id=0 msg=2472948]
-
I looked all over the Award Badge area for a weed wacker badge and couldn't find one. So, I had to make my own. Best wishes. G
:D [attach id=0 msg=2473116]
-
@IMR4198 said:
I looked all over the Award Badge area for a weed wacker badge and couldn't find one. So, I had to make my own. Best wishes. G
:D [attach id=0 msg=2473116]Lawn machine fixer badge would be a great badge.
I’ve fixed several lawn care tools and tractors with my multitools.
My Wave served that purpose today. Had to grab the chainsaw chain with the pliers as it jammed. Then spent way too long filing out a burr on chain. The Spirit file would’ve made short work of it, but then the Wave file diamond side helped re-edge the jammed tooth just a bit.
[attach id=0 msg=2473790]
[attach id=1 msg=2473790]
Cut down a number of trees today and process some limbs for fire… but then it rained harder than expected.
[attach id=2 msg=2473790]



-
Nothing but rain and strong wind here lately. I will have to put the battery back in my Cub tomorrow and see if it will crank. Hopefully I won't have to use a chainsaw this week. Great photos, Banana. Maybe we do need a Lawn Tool Repair badge? Best wishes. G

-
Wingman went along instead of a pair of pliers on the Cub maintenance. Battery was charged up and bolted back in place. The wire retaining clip was difficult. Had to go get a big screwdriver to pry it back on. Not enough leverage on the LM for this.
Good news is the Cub cranked right up and I mowed the highest parts of the lawn. Spring.
Best wishes. G

[attach id=0 msg=2473904]
-
Thanks and great use, Gary
I think a lawn tool repair badge would be fun. Maybe also a dedicated thread if folks are doing consistent repairs. I have a battery Ryobi pusher mower and where whacked I primarily use, but I do have to break out the John Deere ride on for the back lot. It’s a pain to maintain but I’m not buying a new one while it’s still working. We had a John Deere push I eventually gave up on for the time being. Issues outweighed the cost of replacing. -
Today was one of those Wave does it all days. And one of those days where I just started cracking away without thinking about any action shots.
Spent a good deal of time today hunting more wasps. We’re finding all the holes around the stormers. So I used the Wave Phillips and pliers (for stripped screws) to pull off the frame and sprayed those suckers. Some of the seals needed some coaxing so used the pry bar to pop those off.
Then I found behind one of the more deteriorated siding strips the wonderful surprise of an old birds nest and an old massive wasp nest. Thank God there were no wasps. So after I ripped that out I cut with the saw a temporary cover out of plywood. Marked the length with the awl and nailed it in place. The windows and siding are all being redone this summer so it’s just being made livable until we move next month (it’s a family members home we’re staying in).
Next, I positioned ant baits along the outside of the house and snipped the openings with the wire cutters.
The kids and I also made a plastic bottle bird feeder using the awl to poke holes and saw to trim a dowel to length.
[attach id=0 msg=2475841]

-
Double-dipping with this picture but you gotta love MINI's!!! Good thing the screws on this plug were combo phillips/straight.
Craig

-
Used my wave to build a bbq for my neice.

-
This is my first time to use the Wingman package opener. Works fine. It wouldn't take much effort to open your thumb with this thing. It is really quite sharp. Best wishes. G
:D
[attach id=0 msg=2480736]
-
I wonder how many currently produced items run on C cells.
Glad to see that you're getting some good use out of the Wingman! 
-
Fired up the old John Deere mower that almost caught fire a few weeks ago. Got about 10 feet before the mower blades stopped and found one of the wires to the belt rotor was broken in two. It had clearly already broke and was repaired with electrical tape. Why not do the same again? My modded Wave has been sitting near the door so I grab it when I go outside and used it to cut and strip the wire and reconnect. The kiddo helped so it was good fun.
[attach id=0 msg=2487250]

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login