Red Alox
-
Yeah, here’s my process:
- I remove as much as I can with some diagonal cutters
- I tape off around the remaining nub with one layer of electrical tape.
- I use a small, variable speed, hobby bench grinder from harbor freight and on a higher speed remove as much material down to the tape as I can (need a steady hand)
- I remove the tape and slow the speed of the grinder way down and slowly get it as flush as I can. This is the most nerve wracking part. I’ve not found a way to get it flush while protecting the scales as even a few thousandths of an in thick of tape leaves a noticeable bit of the nub when removed
- finally I use a needle file to nock down the edge and smooth out the grind lines.
The key to it all is slow and steady.
-
Thanks mate! much appreciated

-
Thanks Gusto and Explorer

-
What the heck I already posted this in the OC thread but they are all red so here you go.

-
Firs Mate


-
I dun toldja I’m a Soulja !!!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
COMMUNITY LINKS

