What did you use your Leatherman for today?
-
I did several oil changes today (of course), but didn't need to make a funnel. However, I did use the ST300's wire cutters to chop the end of a zip tie after I broke a prop rod clip.

-
I need to replace the funnel I had here buddy
Those wire cutters are great on zip ties! -
Funnels are cheap. I got a couple of them at Meijer for less than $10. Even better, they're American-made!
-
Wow!!! You definitely got my attention with that Dan!
-
Leatherman saved the day today with putting up Christmas decorations at the Church. Used those wonderful wire cutters to cut retaining wire and also some non functional light strands. Unfortunately no action pictures


-
buddy! -
Had to change the batteries on my little one's steering wheel and driving controls toy and the Free T2 worked perfectly. That thing continues to really grow on me.

-
They're great carries!
-
Well, I had to get out a tool with bit driver capabilities so out came the Signal! Tightened the loose Allen head bolts on my kitchen chair. Afterwards, I did the trick with the inner cords from a section of 550 cord so the bit shouldn't fall out at an angle.

-
Great uses, y'awl!

-
Thank you buddy! -
Apple when break during lunch break at training
Bond

-
I noticed that my keyboard pedal been not bouncing well after being pressed. Turned out that was because a screw at one side got lost. I couldn't find any replacement screw at home right now so I cut a small piece of plastic from a Qtip with my Wave+ to hold the pedal in place (hence the white stick sticking out). Until the new replacement screws be shipped here then


-
Nice fix!
-
And I was wondering why a keyboard would have a pedal until I saw "Yamaha" molded in .. -
[attach id=0 msg=2510674]
After texts from my step-daughter at 2:30am asking if I’d got a ring cutter, I’ve just been up to get a ring off her swollen finger.
No luck with ice, cold water, oil, or loops of ribbon, so it came down to the Raptor to cut it off.
No action photo, but a very easy cut. Only problem was getting the cutter between the ring and her finger without pain.
Arc and Mini Tool not required, as the ring was thin enough to pull open by hand once it was cut.

-
That's says it all Crunchie. Exactly the kind of emergency situation the Raptor was designed for and it came through.
-
@Barry Rowland said:
That's says it all Crunchie. Exactly the kind of emergency situation the Raptor was designed for and it came through.Certainly did.
Not easy to get the cutter jaw into position, and I guess 95% of the time they’re being used on swollen fingers.
I suppose a thinner bottom jaw would be too likely to break.
-
Thank God for the Raptor! Now I'm thinking I should get me one...
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login