Opinel and Peasant knife owners club
-
No recipe today. Just my Opinel No.9 DIY. A gift from a friend. Opinel's bid to build a multi-tool, I suppose. Two quarter inch drive bits store in the hard plastic handle. A couple of wire stripper/cutter notches on the blade. Should anyone throw away their plier-based tool and replace it with one of these? Probably not. It does have some limitations. On the other hand, it carries great. It is light and round, and not noticeable at all in my pocket. Your pockets may vary along with your tolerance for something this size.
I would suggest that anyone using a synthetic handled Opi should make sure it is locked when you use it. I am used to just using a wood handled Opinel like a slip-joint. There is very little friction holding the blade open on the DIY. Opens easily. Closes easily. There is a lanyard hole in the handle. It wouldn't be a bad idea for Opinel to put one on all their knives.
I thought of putting some sort of lanyard on this one. Might do it yet. Best wishes. G

[attach id=0 msg=2513768]
-
Good advice on that locking collar Gary.... they're slick knives!
-
And here I thought that was a combo edge.
I sure do like the shape of the blade...sort of a cross between a sheepsfoot and a spear. 
-
You know, it actually is a combo edge. Not a half serrated, half plain edge sort of combo. You might have been thinking about the No. 8 Outdoor knife with its regular combo type blade. The screwdriver bits look like they are quality manufacture. I haven't had the chance to try them on anything yet. The handle is just like a normal No. 9 size, I suppose. The blade is the same length overall as a No. 8 blade, but the actually cutting edge is shorter because of the wire stripper/cutter notches area. It is a strange sort of blade. I have been carrying it ever since I got it. Best wishes. G

-
No recipe again. Found an old dry poplar limb and whittled a few inches off of it. The stainless Opi bit deep and started cutting well. Little bit of break in improved the feel of the edge. Best wishes. G :D
[attach id=0 msg=2514111]
-
Great pic Gary! We have a few inches on the ground here too. That yellow works perfectly visibility wise

-
Gary showing his No. 9 DIY made me think about mine. I got one of the first batch to hit the States probably 8-10 years ago and liked it. Gary isn't kidding when he says to use that locking collar. This is easily the slickest opening Opinel I've come across.
In France, these knives are known as No. 9 Bricolage, which roughly means tinkerer, so DIY fits right on. I've used mine when working around electric, because of that plastic handle. It's not meant for heavy duty, Super Tool kind of work, but just as a handy tool. One thing I've always wanted to try, and haven't until now, is the wire stripper. After using a piece of old extension cord, I have to say I'm impressed 👍. It's the slickest version I've used yet besides dedicated wire cutters and strippers. I used the large and small notch interchangeably because of the large cord I was working with.Pic 1: Vanity pic :D
Pic 2: Cutting the cord from the main section of line. I used the large notch and that wicked sharp blade cut right through.
Pic 3: Stripping the wire
Pic 4: Viola!Like I said earlier, this is a handy tool to have around. I've been impressed with Opinel's products. They think things through and test them to find ways to make them better before releasing them for general sale.




-
Going wood today. I piddled around yesterday and found the same seasoned poplar branch that I tried the stainless steel Opinel on. This time I used the carbon No. 8. It just slid through the hard, dry wood. At least as well as the stainless. Just as sharp as ever after I finished. In fact, I didn't need to sharpen either Opinel after the little trial. The Tootsie Roll is a MRE component. Most of them look like they have been stomped on. The packers missed this one.
10F this morning. Brrr. I decided to combat the cold weather by my usual cooking a pot of beans strategy. Works for me. Best wishes. G
:D [attach id=0 msg=2514604]
-
I remember those Tootsie Rolls! It was 12 degrees F here too, along with some wind. Have a great day Gary!
-
12 degrees is the high temperature at the Farmer X homestead for today.
Some great Opinel photos from both Gary and Barry! 
-
Dan! I'm with you on the warmer climes :D -
I decided to follow up on comparing the cutting ability of an Opinel compared to something else. The something else is a Chinese stainless steel Winchester brand flipper clipper. Found it some while back. Not sharp when I found it, and not very sharp now in spite of efforts at putting an edge on it. I will cut stiffish paper fairly cleanly. Test media was the same seasoned old limb I used the two Opis for whittling. Winchester failed to take a decent sized chunk. In fact, it took a lot of effort to get it to cut at all. Not even close for cutting efficiency to the French folders. I knew the Win was crummy, but it turned out worse than I expected. Best wishes. G :(
[attach id=0 msg=2514844]
-
Great test Gary.... Opinel is razor sharp.
Keep warm buddy!Barry
-
Opinel went for a walk. Strange shadows on the handle. Look like streaks. Dropped my phone this week and cracked the screen. Still works. I taped it up. Best wishes. G
[attach id=0 msg=2515460]
-
Great pic Gary! Sorry to hear about your phone

-
No biggie, Barry. As long as it still works. I drop things which is probably better than losing them. I do that too. Finally got up into the low 40s today. Might snow some Monday. They always say that when there is still snow lingering on the ground it is waiting for another one. Still snow on the ground in spots. Best wishes. G
:) -
Low 40s sounds awfully good to me!
-
Opi went along on a walkabout. Saw a lot of deer trax and raccoon prints. Temps went up some and the road is nice and muddy. Best wishes. G :( [attach id=0 msg=2516262]

-
Pleasant Porch Peasant. Judging from the photo, IMR will need to do some cleaning of the white painted surfaces. Maybe some painting, too. I think I will try the hot water, Dawn, and scrub brush method first. Wind blows the rain in, and squirrels track their grubby pawprints all over. Best wishes. G
:D [attach id=0 msg=2516991]
-
@IMR4198 said:
Pleasant Porch Peasant. Judging from the photo, IMR will need to do some cleaning of the white painted surfaces. Maybe some painting, too. I think I will try the hot water, Dawn, and scrub brush method first. Wind blows the rain in, and squirrels track their grubby pawprints all over. Best wishes. G
:D [attach id=0 msg=2516991]
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login