What did you use your Sak on today?
-
The Ranger 79 got to trim a piece of wood, used to level my old washer and some other house chores. [attach id=0 msg=2530704] [attach id=1 msg=2530704]


-
Used the toothpick to open up the battery compartment's lid, and the eyeglass SD to pull back the battery latch so that I could remove the protective film from my new valve pressure gauge; found out my floorpump was off by 10psi!!!


-
[attach id=0 msg=2531067]
Used the saw to cut some sawbriars wrapped around some privet with wild rose wrapped around all of that. Nothing very heavy to cut, but tricky if you don't want to draw blood. I think the deer have killed off a lot of the multiflora rose. There used to be a continuous layer of these things. Some had stems four and five inches through and climbed way out of sight in the trees. Might be something else killed them. Lots of the trees are dying too.
I did carry a shovel along as well. Just looks like an ordinary old shovel, right? Very heavy rain from time to time here. I had to dig a few ditches. It was so nice a few minutes ago, I thought about mowing some. Now the thunder is rolling and skies are darkening fast. More rain coming. Just can't catch a break. Best wishes. G
::)
-
It's been a while since I've had occasion to use a multi's saw. And like you, I can't catch a break with the weather. I miss hot and dry conditions.
-
I don't use the saw on my SwissChamp all that often. But the times I have used it, it was sure handy as there weren't any other saws around.
-
Much the same with me. I rarely need a wood saw, but when I do, a multi wood saw is more than sufficient. That'll change if/when I start camping.
-
I even had a spontaneous need for the metal saw about a year ago at work. A piece of metal was sticking out of a mic clip. No wire cutters around, but the metal saw, then the metal file took care of it.
I still think wire cutters would be a great tool on a SAK. Same design as the pliers.
-
I have a pretty lightweight Stihl folding saw that fits in my back pocket--ever since I got it, I only sparingly use the wood saw, and that's typically only with the slim Lumberjack/Walker I bought specifically for being blade/saw when the "Walker" reissue came out several years back. Same goes for the Junior 09--both are just bare-bones yard work knives that don't feel like a brick in cheap gym shorts.
At a buddy of mine's place today, I dragged my toolbox for some Torx bits I had, and ended using half the stuff in my own box. Also, the Electrician went from tool roll to my pocket, and the awl and screwdriver were used. Once I got back home, it remained in my pocket ,and I opened my Hot Pocket with the wire stripper blade.
-
I used the saw on my Spirit to cut out a couple notches on a board that went up as a shelf behind our washer and dryer.
-
Saw use for me as well yesterday. I had to cut about an inch off the end of a dowel. No other saw available, but the one on my SwissChamp did the job quickly.
-
It was a team event today. Mag glass on the SwissChamp along with the pin and sharpened tweezers from the MiniChamp Plus mod to remove a metal splinter from my finger.

-
Did this about a week ago and forgot to post it then…
Used my Deluxe Tinker to replace my van’s trailer running lights fuse. The Vic pliers are great for those small automotive fuses.
-
A long time ago I made one of those ranger beads things. Didn't use it much and used paracord and some beads I "borrowed" from my oldest doughter.. I thought it would be a fun hungover activity to do a new one. Used my new handyman to cut the cord and pliers
And before anyone notice, I can count to both 9 and 10 but I got a brainfart and put 10 skulls instead of 9.. But that's only make it one more cool.. Right?!

[attach id=0 msg=2532344]

-
Took my new(ish) Explorer to take picture for the /post/1924733 and as a teaser for the /post/2522851
[attach id=0 msg=2532352]
-
The main blade on my Bantam was used to cut plastic sheeting for a spray paint project and the combo tool was used to open a couple items in the last few days.
-
Last night I used my spirit and bitkit to reassemble a ikea bedframe and today I used it to put together a ceiling fan
-
The old style awl is the perfect tool for breaking Pu-Erh tea cake into pieces.


-
In the past week, I've used the combo opener on my Bantam to open a beer bottle cap and also the Bantam blade to open two packs of hot dogs at a birthday party yesterday.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

Nice Shou Puerh