What did you use your Leatherman for today?
-
Good to hear you were able to install your (space saver) spare and continue on. A lot of cars don't come with a spare any more which means for many tyre failures you will need to be taken away with a flat-top recovery truck.
In my VW Golf the lug bolt cover remover was with the spare wheel, jack etc in the boot. It is just a piece of wire with an L shape (to hook on the inside of the cover) and a round circle for a finger to pull on.
PSA After the tyre place has repaired your tyre, then loosen and re-tighten all the lug bolts to make sure they weren't over-tightened by a gorilla using too many ugga-duggas on the air-wrench when installing the fixed tyre.
-
@Barry Rowland said:
I wound up doing the same thing with my Beetle tire. I couldn't find that hubcap remover to save me! Once everything was put back together, it turned up....in the glovebox
I tore the car apart but I'll bet like you I find it when everything is said and done :ahhh
@gregozedobe said:
Good to hear you were able to install your (space saver) spare and continue on. A lot of cars don't come with a spare any more which means for many tyre failures you will need to be taken away with a flat-top recovery truck.In my VW Golf the lug bolt cover remover was with the spare wheel, jack etc in the boot. It is just a piece of wire with an L shape (to hook on the inside of the cover) and a round circle for a finger to pull on.
PSA After the tyre place has repaired your tyre, then loosen and re-tighten all the lug bolts to make sure they weren't over-tightened by a gorilla using too many ugga-duggas on the air-wrench when installing the fixed tyre.
Happily the car had everything BUT this spare tire wise....and always good advice RE the tightening.
-
Fixed (bandaided) the oakley latch ex glasses "sock" (left arm) . It's splitting at one end. Cut a piece of heatshrink with surge and cricket helped to shrink to size. That should hold up well before (if I can) get the replacements.
It also answer my wife why I am carrying strange things and my stuffs are mostly black.


-
My Surge helped me today car repairing, pliers was helpful holding nut while installing bolts in place, last tightening was done by proper tools.
[attach id=0 msg=2532072]

-
Over the winter apparently the nuts holding porch swing chains onto bolts have worked loose, one fell in the grass and had buy replacement.
The ST300, checked awl nuts to ensure tighten.
After completed this pose was captured.
[attach id=0 msg=2532279]
-
That wonderful awl!
-
:D

-
Not the clearest photo, but I used the Crunch to clamp the fuel line on my Mum’s mower while I took the pipe off to drain old petrol out of it.
[attach id=0 msg=2532332]
New fuel didn’t do the trick, unfortunately, and the Crunch and P4 got involved in stripping the carburettor down. No pictures, as that was already a three-handed job.
Back home, using the Free P4 to cut garden twine to build pyramids for my peas.
[attach id=1 msg=2532332]


-
Had to replace a window handle today because a few days earlier I tried to open a window, it got a bit stuck, I applied some force and - oh well - handle left in my hand 😬.
Consequences of visiting gym on a regular basis 🤣.Really like the ratchet - LM should have released this accessory years ago 👍🏻
[attach id=0 msg=2534877]

-
After all the years of hesitation I finally bought a pocket clip. Awesome. Should have bought it long ago. Now I carry my Wave everywhere I go so it’s a good thing by to keep it safe on me. You never know when you might need it to build a bed in the bomb shelter if need be just like in the first days of war.
So, well, I used my Wave with a pocket clip to see if I like it and I do 😃
[attach id=0 msg=2535100]

-
I felt the same way until I put a clip on the Bond I had. I wish I had done it before too!
-
A BOND’s awl was was utilized to make a few dribble water bottles to slowly hydrate my outdoor flowers today. Slow and steady saturation of the potting soil…
[attach id=0 msg=2535716]
[attach id=1 msg=2535716]


-
I did a bit of gardening this morning, a good chance to test some new long protective gloves.
Advertised as thornproof, cutproof, stingproof.
[attach id=0 msg=2536106]
They’re useless.
Very tempted to chop them in to tiny pieces with the Raptor and post them back to the supplier.

-
@Crunchie64 said:
I did a bit of gardening this morning, a good chance to test some new long protective gloves.Advertised as thornproof, cutproof, stingproof.
They’re useless.
Very tempted to chop them in to tiny pieces with the Raptor and post them back to the supplier.
Well that's disappointing and a total waste of time and money. I'd be petty enough to cut them up and send them back anonymously with no postage paid, so at least the seller is out of pocket. >:D >:(
-
@Crunchie64 said:
I did a bit of gardening this morning, a good chance to test some new long protective gloves.
Advertised as thorn-proof, cut-proof, sting-proof.
They’re useless.
Very tempted to chop them in to tiny pieces with the Raptor and post them back to the supplier.I think that might weaken your case for complaint

But very frustrating - And I gotta admit they do not look too robust - You'd expect a rubber coating for those sort of claims
-
Got this at a deep discount from Barnes and Noble....so often with toys I find myself pulling the CyberTool off my desk but for this the body was too fat (like my own). So my primary EDC did the trick and perfectly.


-
@Crunchie64 said:
I did a bit of gardening this morning, a good chance to test some new long protective gloves.Advertised as thornproof, cutproof, stingproof.
They’re useless.
I work in and around gorse, barberry, hawthorn, blackberry and bush lawyer on a daily basis and I am yet to find any glove that is 100% thornproof.
However, welding gloves are the best I have used for dealing with prickly things. -
My Leatherman Style CS is the only one I use nearly every day. The scissors are quite good for everything from opening packages to trimming stray threads. The nail file has a good screwdriver tip on it, that works great for tiny slotted and Phillips screws. The blade is tiny, but usually good enough for most small jobs. I keep it on a belt loop, which is very accessible and convenient, using the combination carabiner/bottle opener. I can't imagine being without one.
-
Well…nothing today
Sent from my iPhone using Tapatalk
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login