If you want something done right....
-
Whoa, Good Mod-Job...
:D -
Top job that matey

-
that's fantastic.
So why can't SOG manage it? ::) -
Does it close?
Looks good!
-
That is just freakin' awesome! Amazing job, J-sews!

I never really understood what the problem was that stopped SOG from releasing theirs. Now I am even more confused... ???
Which model of cutter did you end up using?
-
I ended up using the one pictured in the first post of this thread :)

But it was far too thick to fit within the SOG handles, so after cutting off the excess handle length, I ground it down to proper thickness. It ended up being about 3/16" (4mm) thinner than it started. My biggest worry was that removing all this extra thickness would end up taking the "head" off the pivot pin, allowing the two halves of the cutter head to fall apart. Luckily that didn't happen though. :)
Then it was a matter of welding a blob of metal onto the end of each handle stub, shaping it to size, then drilling a hole through for the handle pivots.
An unexpected hurdle was the little rivets that go through the SOG handle gears. :-\ The dang things stick out the backside of the gears. I never noticed the slot SOG puts in their plier heads for clearance. I had to machine a slot through mine for the same reason:

Really the only shortcoming of this mod is that the cutting surfaces don't extend all the way down to the pivot. See in the picture below where there is a "hole" about where you would normally have hard wire cutters on a regular multitool? Its there because of how much extra thickness I had to remove to get the cutter head to fit. I actually ground all the way through at that point.

It couldn't be helped though. :-\ Still and all, it works great! And because the cutter is made of hard tool steel, it doesn't really need a hard wire notch anyhow. :)
-
Superb job Bob

-
That is quality Bob. Great job

-
Holy Cow Bob, that's fantastic

Sog called, they want to know what your doing next Saturday! :P
-
@WhichDawg said:
Holy Cow Bob, that's fantastic
Sog called, they want to know what your doing next Saturday! :P
Actually I just spoke to them. They're peeved that the cutter head doesn't say SOG SOG SOG SOG SOG SOG all over it :D
-
Well done Bob, that is something to be very proud of...so.....Can I have it.
-
Holy Cow Bob, that's fantastic

Sog called, they want to know what your doing next Saturday! :P
Actually I just spoke to them. They're peeved that the cutter head doesn't say SOG SOG SOG SOG SOG SOG all over it :D
Umm...are you going to make more for us :P
-
Bob you are one clever cookie
.I would be interested to hear with the help of compound leverage , what that bad boy can cut
:D -
-
Nice job Bob!
So the way this works is I just send you my PowerLock and a pair of side cutters and in a few days you send me back your homebrew PowerCut, right?

:D
-
bob
you are my hero. I am amazed! -
When Bob does something, he does it right! (eventually) :D
-

AWESOME job mate

-
Job well done Bob.
Chalk another tool on the list that Bob has and the rest of use never will. :D
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
