Official Pioneer Owner’s Club!
-
@Tuisto said:
How do you perform the nubectomies? Do you snip with like a bolt cutter and then file down? How do you file down without hitting the scales?That is pretty much what I do. I use jewellers files that are narrow to minimise any scale damage. I also protect the scales with masking tape and put blue tack / Prestik in the tool slots to minimise any filings getting into the pivots. Once the filing is done I use very fine metal sand paper to make it smooth. I cut the sand paper in 1.5mm widths to complete the removal process. I find using the fine grit paper (up to 1500) you get a very smooth factory finish.
Pete
-
This is pretty much my technique too, although I was looking at a Scientist that I modified this way 30-odd years ago, and I regret it now. :(
Nice to see you, Pete!
-
That’s pretty close to my process, though lately I take shortcuts to do it faster by using a small bench grinder.
I snip off most of the nub with side cutters, then mask off the area with electrical tape, stretching it over the pivot area to avoid metal shavings getting in. Then I use the bench grinder to remove the remaining 99%+ of material. Then finish with some needle files to smooth everything out.
I used to use just the needle files instead of the grinder, but it does take a long time. And since these are all users for me, the risk of nicking the scales a bit isn’t a bother for me.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login