Anyone ever put a Victorinox 91mm Pliers in a 84MM Frame?
-
I've been trying with this too, modding the backspring should be possible, but I don't know how to shorten the plier short of cutting and Tig welding it. It might be easier to use a Wenger 85mm plier.
-
The Wenger pliers is an interesting idea for sure. They're pretty different from the Vic ones though, so it depends on what trouthunter is looking for, functionally, aesthetically, etc.
Personally I'd be more inclined to grind down the Vic pliers. I wonder if you could basically scale down the current head, so it'd be shorter and narrower? I'm also wondering if you could move the pivot where it connects to the knife, to make them shorter without sacrificing the pliers head.
-
So this is the 91mm plier over a 84mm liner, there is room to redrill it but you will still need to trim down the handle for it to close. Also, would need to reshape the pivot area. You'll need to fab up a backspring from 2(might be 3, I don't have the thickness in my notes) 84mm saw backsprings.
[attach id=0 msg=2589276]

-
I looked the pic over and did a little mod myself to it, it looks like you’d pretty much have to put the pin where the spring hole is, that and cutting the top back so it locks when open would pretty much leave nothing for strength? This project looks to be interesting!
JR
-
I have a stupid question but is there an issue with using bigger rivets and enlarging the pivot holes of the other tools? Kinda the opposite direction of modifying the pliers but instead modifying that section of the SAK.
-
@Old Boy said:
I have a stupid question but is there an issue with using bigger rivets and enlarging the pivot holes of the other tools? Kinda the opposite direction of modifying the pliers but instead modifying that section of the SAK.Plenty of 84mm mods get done using 2.5mm pivots, since they are easier to source than 2.2mm pivot screws. Just ream or drill out the tools.
-
@MadPlumbarian said:
I looked the pic over and did a little mod myself to it, it looks like you’d pretty much have to put the pin where the spring hole is, that and cutting the top back so it locks when open would pretty much leave nothing for strength? This project looks to be interesting!
JRYeah looking at that pic it seems like changing the back would be almost impossible. I took it into photoshop and mocked up roughly what grinding down the jaws would look like: it leaves you with a pretty small area, unless you also want to grind into the mouth toward the bolt. The Wenger pliers really might be the best option.
[attach id=0 msg=2589454]

-
Lots of good ideas! It beginning to become clear that this is not going to be a project I am capable of doing.
-
I found an example

-
@trouthunter said:
I found an exampleNice,
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
