modded SAK for whittling
-
Got my whittling book now.... no tree is safe :D
-
That's about as simple a layer mod as you can do. All you need to do is get a Hiker, pop off the scales, drill out the pins, gently tap them back (but not all the way out) so as to remove the opener layer only, put the outside liner and bushes back in place, peen it over and stick on the scales. Easy.

As to the small blade I just used a series of diamond stones to first make the profile I wanted and then re-do the edge bevel. Again, as the small blade is so thin, this really is less work than you might think.
-
@Spork said:
I think/hope it's his fingers :o
Lovely mods... I like taking the opening layer out too as it's mostly redundant in these things.
How does one go about getting lovely mosaic pins in a SAK scale then? They look

There is a mosaic pin article at SOSAKonline - you need to log in to see it.
OK I'm slow. So are the Mosaic pins then just decorative and not really holding the knife together?
-
@Spork said:
I think/hope it's his fingers :o
Lovely mods... I like taking the opening layer out too as it's mostly redundant in these things.
How does one go about getting lovely mosaic pins in a SAK scale then? They look

There is a mosaic pin article at SOSAKonline - you need to log in to see it.
OK I'm slow. So are the Mosaic pins then just decorative and not really holding the knife together?
Aye.
-
Spork,
Have you ever thought of putting together a 4 bladed SAK with just whittling blades? Just curious
because you do such a great job of your mod's. :)Gareth,
I have that book on loan from our Library and just love it. The branches around here are plentiful.
Nice job on your woods! -
I suppose it's possible on the 84mm frame. Personally I would put the saw between the blade layers make it easier to access the nail nicks. I built a "Doublesport" that way.
You could use the cleaned backed-springs from the MFV or Recruit for the blade layers and the woodsaw spring is also clean-backed. It would be necessary to use an older thick-tang main blade...or make a spacer for the additional blade layer.
I've done a couple of 2-layer, 3-bladed whittlers...


-
those are really nice. I love the 3 bladed ironwood unit in the bottom pic.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login