Show off your Sak mod's!
-
Good to see you having a bit of 58mm fun :D
So what's next
;) -
-
:D
I'd say move to 74mm but its not much better actually, just stiffer springs. What about 108mm :P
-
Nice work Gareth... I've been avoid that 58mm tinkering myself! :ahhh
-
-
Enabler.... ::)
I have a few classics lying around but I'd be more interested in the harder to find parts to play with ;)
-
-
I think there are a couple of action shots of it on the forum somewhere
back in a sec...Better pics..


Its looking a bit rough theses days. Two years of daily carry in my change pocket can do that to a SAK :) Still works fine though, was using it this morning, in fact its probably my most used SAK.
-
I've been mulling a 74mm combo tool mod with Alox Money Clip scales...
-
-
Two large blades, small blade, nail file, scissors, opener. I've just treated it and my Scientist to a sharpen, they deserve it :)
-
What do you guys think of adding a Combo tool layer with both Phillips and Flat head tools? Too redundant?
-
@Spork, Lord of Lime Jello! said:
What do you guys think of adding a Combo tool layer with both Phillips and Flat head tools? Too redundant?I might be tempted to add the orange peeler rather than the flat headed combo tool. if your not going to use that the I don't see the flat head combo as redundent.
-
I was thinking of keeping the full compliment of Executive tools. Adding a third layer with a combo tool leaves a slot open ...unfortunately, there isn't another unique tool I can think of for that.
Maybe I'll have a look at remodeling an abused main blade into a pick/pokey thing tool like that found on the Wenger PTC.
-
Ah OK, I see the issue.
my first thought was the possibility of using another 58mm tool/tools, but I think the nail nicks would be lost, right?Hummm...
-
@Gareth said:
Ah OK, I see the issue.
my first thought was the possibility of using another 58mm tool/tools, but I think the nail nicks would be lost, right?Hummm...
Putting the layer in the center of the knife may allow the nicks to stand clear. Since they are 58mm blades the nicks are closer to the pivots...which may make them more accessible on a 74mm frame.
-
I have to say this having to balance out the sides is making my brain hurt. :ahhh
I think if it were me I'd go for something like this: main blade+small file, orange peeler, combo tool, scissors. Almost all of the original functions of the Executive but with the added combo tool. In fact that sounds like a rather good SAK to me, something to have a go at myself in the future (even if you decide to do it ;)).
-
I've got it. SPARE SCISSORS!......OK, maybe not. :-\
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

