Leatherman Wave, opening tools issues
-
The bit driver device means it is a "New Wave"
Sounds like you've narrowed the problem down to friction then. I've recently disassembled and reassembled a bunch of Leatherman Charges, very same mechanism as your New Wave. I can say from experience that it takes <u>very little</u> tension on the pivot screws to cause the blades to become tight. The difference between "just right" and "too tight" can be as little as 1/4 of a turn on the pivot screws.
So the big question: does your Wave have 5-star Torx screws, or 6-stars?
-
Thanks for the info on manufacture date. It is "0607" which means that it is either hot off the press, or just over a year old.
Also, thanks for the info on pivot tightening. The torx screws are 6 stars with a pin in the middle. the end screws, which are tight are smaller than the pliers/blades screws. are they #10 or smaller? I guess I can just carry the wave with me to the store and check the sizes on the spot. -
One last point on pivot screw loosening:
It is VERY important not to strip out the flats on the crossholes in the frame.
Long story, but the pivot axle isn't completely round; it has two flats on it. The crossholes through the frame are also flattened, to match. This keeps the axle from rotating when you fold out a tool, which in turn prevents the "clumping" that used to occur on most multitools ten years ago. If you rotate the wrong torx screw-head, it will strip the flattened holes. (Been there, done that!)
Check out the picture below. The screw on the left is actually the flattened axle. It needs to be held steady. (Not at all difficult to do)
The screw on the right is the real screw. Try loosening it about 1/4 turn. (Not difficult either) That should solve the opening problems.Bob

-
The torx screws are 6 stars with a pin in the middle.
You might have to order them online, or buy them from someone here.
I've been seeing 6-star security bits everywhere. Even my local hardware store has them now. (Wish the 5-stars were as easy to find)
-
Where would your Wave be if it weren't for Victorinox? That wrench and ratchet look awfully familiar!

Def
-
I had the same problem with mine. Send it to warranty and they will replace it.
-
@Leatherman123 said:
I had the same problem with mine. Send it to warranty and they will replace it.Thanks for the info. Unfortunately, sending it in under warrantly would be my last resort, because shipping charges from Ontario, Canada (expecially for trackable package) would most likely be much more than the cost of 2 torx security bits. Plus, if I get the bits, I would get to keep them for future adjustments :)
-
Not really- you could probably just drive it there. Leatherman's Canadian representative is Eastern Outdoor Sales in Oakville:
166 South Service Road East
Oakville, Ontario
Canada L6J 2X5TEL: 905-825-3103
FAX: 905-847-3047
eosi@sympatico.caDef
-
Thanks, Def! I will give them a call. I do hope it is a service centre, not just a sales office!
-
Nope- they handle all warranty claims in Canada.
Def
-
Thanks for letting us know that the 4 digits number inside the handle of the Wave stands for month and year. My Wave has this marking "1206".
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login



