Question About 84mm Phillips Mod
-
I cannot remember if this has come up before, but with the new shorter phillips from the Spartan Lite work in the 84mm frame without having to be resized? I was thinking the old magnifier and the new phillips with a Recruit spring might work but I don't have one of those Phillips on hand to test it out.
-
I've not tried it, nor do I have the parts to look at, but it's a good idea and I'd be interested to know as well. :)
-
I just realized the biggest inhibitor may be the width of the spring- neither of the recruit springs are as wide as the mag/phillips. A liner could maybe be trimmed to create the necessary width without interfering with the spring's function. Hmm I shall thoroughly explore this option. My thought is that an 84mm Scientist would be much cheaper to create as the 84mm donors (Bantam/Waiter) would be significantly cheaper to acquire than a Compact. Hopefully a liner isn't too thick.
Er, on second thought, all that's needed for a Scientist is a Compact and an Explorer- for my idea you would need an old Explorer, a new Explorer (or Spartan Lite) and a Bantam (possibly a Recruit as well)- it would possibly be more expensive :/ I suppose it all depends on what you already have laying around.
-
An 84mm Scientist sounds like a great project. I hope you get something sorted out, I'd love to see one done.

-
The biggest problem you will have to deal with is not the backspring because you could use two and maybe thin one or both out. The biggest problem is the 84mm use 2.2 mm pins on the whole knife but the 91 mm use 2.5 pins on the outside two pins but 2.2 on the inside two pins. Drilling a hole larger is not too bad if you have a good bit but I do not know how to deal with a hole that is already two big.
-
I seem to recall dismissing the new style driver for 84mm mods when I first looked at the issue but that was quite a while ago and I can't remember why
It might be time to revisit.The larger diameter hole may not cause a problem. On some tools it doesn't affect function. A factory example of this is the electrician blade that was once used in place of the small blade.
-
I think Nemotron over at SOSAK just did an 84mm Passenger and he said something about using the "Normal Spring"- I assume he meant the 91mm? I'm not sure though. Time for me to cannibalize a cheap Champion to get my mag and spring. I suppose it's plausible- that spring doesn't even interact with the two outside pins- as long as the two inside pins are equidistant on the 91mm and 84mm the only foreseeable problems could be excess hanging out the ends or insufficient tension.
-
Okay I talked to Nemo and he says that he just used the 91mm phillips/mag spring and only had to trim one end. Needless to say, I am thrilled, but to try this I need one of the new short phillips- anybody have one they want to sell or trade for something ? :)
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login