I finally received my old display case today.
-
Thank you. That solved the mystery.

-
trivial question: since some of these knives have been fanned continuously for 20 years or so in a display case, do you notice any weakness in the backsprings? It would be something if they were still just as strong.
-
@Jmora said:
trivial question: since some of these knives have been fanned continuously for 20 years or so in a display case, do you notice any weakness in the backsprings? It would be something if they were still just as strong.Although prolonged fanning isn't recommended, you should only truly worry about Wengers that have been fanned for a while; prior to the current backsprings, they were known to have issues with partially fanned tools, IIRC.
-
trivial question: since some of these knives have been fanned continuously for 20 years or so in a display case, do you notice any weakness in the backsprings? It would be something if they were still just as strong.
Although prolonged fanning isn't recommended, you should only truly worry about Wengers that have been fanned for a while; prior to the current backsprings, they were known to have issues with partially fanned tools, IIRC.
While I probably do not have any Wengers that have been displayed in the fanned condition I have found numerous Wenger SAK's with what I would call weak back springs. I do not know if it has anything to do with use since some of them look rather unused. It could be that Wenger used some inferior steel or perhaps got a bad batch or 2 but whatever the reason I must agree here that some Wengers do exhibit a weak back spring problem.
Now concerning Victorinox, I have usually found that any Vic I have noticed with a weak back spring it is usually caused by the liners, either wear or gunk seizure of some kind. There are a couple of aberrations though. I have a couple of 84mm SAK's from the 1960's era that exhibit a weak opener layer back spring. Both are rare models and one looks much more worn while the other looks less worn. It must have been a problem with just that one spring design or perhaps maybe a bad batch of steel, etc. I am no expert in the heat treating process or and any other process that steel goes through for back springs so take my guesses as just that, a guess. ???
Had to edit since I had made a mistake in the layer on the 84mm Vic with bad back spring.
-
No issues with the back springs.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login