Opinel Knifes
-
Turnstone,
It is surprisingly easy to to with a 'dremel' or you could do it with a half round file and some sand-paper
As I have said I have owned this knife for years and I wish I had done it ages ago ::)
Also I think you should try rubbing this area down with some sand-paper as well, your hand will thank you for it

-
@Mike, Lord of the Spammers! said:
Probably not. :D
Mind you, with all the options available I'd probably take months just picking the size I wanted :ahhh
I'd go for a nice legal edc No6

This thread's got me wanting to pick up one of them now. I've got a No4 (nice but too small) a modded No8 (pic earlier in this thread) and a No12 (great knife though a bit big), but I never use any of them as EDC. :-\
-
Since when do they have pocket knives except box cutters! i have a rite aid right down the street literally so i will look next time.
-
How did you install the grommit on the lanyard hole? I have an old one where I drill out the handle a long time ago, it could use a grommit.
It's an old #7 with carbon blade. Is there any way to loosen up the handle? It has gotten real stiff with age and I'm not sure if these can be lubed...
-
Its a piece of 1/4” brass tube, I drilled the hole and just forced it in there, I should have used glue but it was so tight I didn't bother
Maybe I will add some glue if it becomes loose
The wood will swell if it gets damp which will cause the stiffness, maybe try keeping it in a warm place for a while or try soaking it in some kind of oil,
I have started using linseed oil thinned with white spirite but there's lots oil you could try
-
Where would one get linseed oil from?
-
@Mike, Lord of the Spammers! said:
Probably not. :D
Mind you, with all the options available I'd probably take months just picking the size I wanted :ahhh
I'd go for a nice legal edc No6

This thread's got me wanting to pick up one of them now. I've got a No4 (nice but too small) a modded No8 (pic earlier in this thread) and a No12 (great knife though a bit big), but I never use any of them as EDC. :-\
Scrub that. I've now taken the locking ring off my modded No8. With the blade being reshaped it's now a handy, though coincidental, 2 7/8" long. Now perfectly UK legal EDC.

-
How is it without the ring though?
-
The pivot is stiff enough on this one not to give me any real concerns TBH. I'd perhaps think twice about stabbing it into something and pressing down, but for the vast majority of cutting I can't see it being an issue.
it's this one (less the lock ring) for those who can't be bothered to look back through this thread. :D

-
I took the lock off mine to make it UK legal. Works absolutely fine for my needs, and if I want to use the point, I hold it by the blade, or just make sure my fingers aren't in the way.

-
Wickes

When I was much younger and didn't know a whole lot I soaked the end of my one in 3in1 oil and it didn't do it any harm :-\
I am not recommending that I'm just saying it probably won't matter too much what oil you use teak oil even olive oil will not harm your knife
I am using a 50/50 mix of linseed oil and white spirit at the moment as its recommended for Axe handles by some people
-
I'll be picking some up then.
And an Opinel it seems. :D Number 7 for me I think. -
I bet someone out there has a link to a site with Opinel knife sizes

-
Heinnie give a good size guide in inches.
http://www.heinnie.com/Knives/Opinel-Knives/Opinel-Carbon-Steel-Folder/p-92-469-4069/
hence a No6 without a locking ring is the largest UK legal EDC opinel you can use.
-
That's great!

Thanks Gareth

No.6 2 7/8in Blade
No.7 3 1/8in Blade
No.8 3 5/16in Blade
No.9 3 1/2in Blade
No.10 3 ¾ in-ish Blade (guestimate measured from my knife) -
Well I'm now looking around and having trouble finding a No6 without the locking ring, I'm sure you used to be able to buy them. ??? Either way it's not to hard to remove the ring anyway.
-
They used to be VERY common on ebay ::)
-
Some Opinel patina

-
Ahh, the humble Opinel. A fine knife if you ask me. I just love the simplicity of these things, and have 2 No 6's.
As for the sizing question - it's quite easy really. The number (roughly) refers to the length in cm
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login