Removing serrations
-
Has anyone ever taken the serrations off a blade before with reasonable success? I've got a
Vaquero (cold steel) that has very small shallow serrations, like on a cheap bread knife that I
very much dislike and wondered if it could be done with a reasonable amount of success or
would it just be a failure on a knife such as that? This blade is mint and I just don't carry it
around because I don't care for CS serrations. Thanks. :) -
I had an SOG Auto Clip that was half serrated and I used a belt sander to remove them. Turned out alright. 60 grit belt, light pressure and finished up with a stone.
-
Did it on my Spirit with a diamond stone :)
Took a long bloody time though :-\
-
It's possible to do it, but not something I'd suggest.
Cold Steel's AUS 8 is pretty hard (something like 58-59 HRC) so the actual sanding will take a long time, unless you use a grinder or belt sander at which point you really have to make sure you don't ruin the temper on the steel.
-
I don't know why Cold Steel would put needle-thin serrations on some of their knives - that could never be re-sharpened.

-
Thanks for all the comments guys! Yeah I consider them to be the worse serrations I've ever used
on a knife, and your right they are so small and shallow I know when it gets dull I wouldn't be able
to sharpen them.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login