Broken Drivers.
-
Im Kinda guessing that the Hollow ground grind on them might be the culpret. But I am also thinking maybe a batch issue. I found it wierd that it happened with 2 of them on the same tool.
-
-
That is exactly how mine look.
-
Crappy pic, but I figured it would show what mine did.

-
HC was it the small driver that chipped both times for you
.A bad batch of brittle small drivers
. Do manufactures heat treat/harden their drivers

-
Thats what I am thinking. I am thinking the born on dates might yeild something.
-
@MultiMat said:
A bad batch sounds possibleHere is Medic's chipped driver
The thread link -------> /topic/9605
Mine looks exactly on my blast too
not sure date, if its a bad batch then I got from the same one twice?
I chiped mine (under normal non abuse use) send it away came back all new and good
first day out, chipped again.
anda again i was not trying a rusty or anything too difficult screw.
anyhow screw it i thought and ground an edge back on it
sure likely voided warrenty
but im sure it will chip again and again -
I broke that same driver on my Blast, which was born in 06.
-
I'd say it's not looking like a single bad batch, too many different tools from different years. It could be the LM fly pretty close to the Sun with their heat treatment tolerances and (combined with the small driver shape) it just sometimes ends up too fragile.
The flipside is that this is also one of my favourite drivers to be found on any MT, so I'm not sure I want LM to do much about it.

-
I guess the trade off is any Vic or SOG slotted driver of that size would have twisted long before the Leatherman version chipped.
-
@gafftapegreenia said:
I guess the trade off is any Vic or SOG slotted driver of that size would have twisted long before the Leatherman version chipped.That's not very true.
I had an 07 blast that the medium driver chipped on. I was using it in a phillips screw, but it had a great hold and should not have broken. I had barely started to torque it when it chipped, and I remember that all I could say was "WHAT?!". Since then, I have used the can opener phillips on a vic supertinker to twist really hard on a frozen screw, and I used much more pressure than I did when I broke my blast screwdriver, and the supertinker doesn't even show a scratch, much less a twist.
-
Interesting. I chipped my Blast driver by torquing down on a set screw in an 20 amp electrical connector, and I've put a slight twist in the Vic can opener tip using it on equipment rack screws.
-
The very edge of the drivers on my core have bent just a little but is still like the drivers on it far more than my swiss tool which is the next best. I like the length, width and grind
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login