PST Pivot Removal
-
I used a SOG PPP and a SOG Toolclip on mine ... basically you need to use the "nut driver" part of the pliers not the flat section, keep a steady pressure and make sure whatever pliers you use sit fairly flat to the tool so you get a good contact rather than just being on the outside edge

-
I have no problem using the regular pliers section of another leatherman or any regular pliers for that matter. Side on not end on. Helps to take the weight off the tool you're trying to unfasten as well, between the knees or lying flat on a table etc.
Edit: I was too slow... 50ft is on the money.

-
Gator grip socket

-
I have tightened pivots on a ST200 with two pairs of small needle nose pliers.
It's a bit tough to get a grip at 1st but it's doable :) -
The non-EOD cap crimpers on Leatherman's with them work really well.
Also, the fine toothed section of the plier head on the ST300, and the MUT work well, because of the way the side of the head in that area is flat ground instead of being rounded slightly.
-
Thanks for all the great advice.I used my Wave on one side and another PST on the other.After much cussing and discussing the pivot broke loose and I got it out.The key that I have may be a problem as it may interfere with the plier tips.Oh well, that's another day.Thanks again.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
