Show off your Sak mod's!
-
Well I wouldn't have if it wasn't made of plastic. Maybe I'll upgrade it with a bushido special.

-
The only lenses I could find (after 4 stinking days of internet searching) that fit them perfectly are laser optics quality Schott glass and cost $37 each. Even with waterjet cut bezels I'll still have to assemble, fit (I have to cut a bit of an accommodating radius into the backspring because I make them slightly bigger) and polish them so I think it will be at least a $100 option on my knives. But I will have lots of the clear plastic ones for trade fodder.
-
yikes!
umm..
http://www.dealextreme.com/p/1-led-with-2-magnifiers-black-589
http://www.dealextreme.com/p/30x21mm-jewelers-loupe-magnifier-8186
have you looked into ones made for medium sized flashlight heads? They are often used to make 'throwers'
-
I had to have a very specific diameter and thickness to fit the envelope that the knife allows and I was afraid of how many loupes I'd have to buy to find one just right. I'm squeezing a 20mm lens in mine. I just used the same rule that applies to building a precision long range rifle, spend as much on the glass as the gun.
-
How about using part(s) of a fresnel lens?
-
Here's a thought. Try a gun sight made for a bb rifle. Daisy has them cheap.
-
Here's another option for getting the magnifier to fit in a 93mm with out sticking out too far.

It works better than you'd imagine as you can grab it from the sides.
Thinning out the backspring to allow an unmodified magnifier to fit would seem sensible but I'm not going there. Every time a backspring gets thinned there seems to be a follow up tale of woe about it snapping :ahhh I'm just not brave enough :D
-
@Neil said:
Here's another option for getting the magnifier to fit in a 93mm with out sticking out too far.
It works better than you'd imagine as you can grab it from the sides.
Thinning out the backspring to allow an unmodified magnifier to fit would seem sensible but I'm not going there. Every time a backspring gets thinned there seems to be a follow up tale of woe about it snapping :ahhh I'm just not brave enough :D
I was worried about the backspring snapping so I made the transition gradual and ground it slowly not letting it get past warm to preserve the temper. Then polished it back up to remove any stress points in the grind lines. Time will tell.
-
A mod Neil did for me is like that and it works great

-
Here is my mod built to my specifications by Neil B.
-
That's a great looking SAK... enjoy

-
I like the look of that mate, good tool combo.
Is it going to be a user? -
horn swisschamp




-
@Sidhartha said:
horn swisschamp

that looks really nice

-
'Tis a good looking SAK

-
@Sidhartha said:
horn swisschamp



Nice
that one's a keeper :) -
@Sidhartha said:
horn swisschamp



Quite fetching indeed! Looks like you might could have rounded off the edges some more.
-
Lovely mate.

-
horn swisschamp




Quite fetching indeed! Looks like you might could have rounded off the edges some more.
That is really

Without being rude I think Stressmaster may have a point
but 
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login