clever,clever leatherman
-
Once the clip is removed would you suggest putting the torque screw back in or leaving it out ?
-
That is pretty dang neat. How well does the "wrench" retain bits? I have a ratcheting offset bit driver, but it takes specialized bits with a ball detent. I would love a magnetized alternative that takes standard bits.
-
I'd leave it out dunc.i'd be afraid of losing it.any fluff that gets into the threaded bolt can easily be fished out with a toothpick.
I doubt very much this clip could be used as a wrench to do any tough jobs.its just handy that it does fit common bits.
-
So as I see it, all you need to do is take a Torx bit, place it in a bit driver, unscrew the fastener that is retaining the clip, remove the clip, take the Torx bit out of your bit driver, and then you can use the clip that you just removed with your bit driver as a bit driver.
Is it just me, or...

-
@turnsouth said:
So as I see it, all you need to do is take a Torx bit, place it in a bit driver, unscrew the fastener that is retaining the clip, remove the clip, take the Torx bit out of your bit driver, and then you can use the clip that you just removed with your bit driver as a bit driver.Is it just me, or...

I'm right with you Paul, it's very interesting that there is a hex on the pocket clip but...how would you be able to utilize this "feature" without taking the tool apart with another tool.
The hex is similar in design to the kick wrench I mean pocket clip that has the fine spline in the end of the pocket clip that coincidentally can be used to remove the PST style fasteners. Using a hex is easier to produce and unfortunately can not be used to tighten up your PST style fasteners.
Bruce
-
I actually think its intended as an added measure to avoid clip movement. The hex shape prevents any side to side. That and the little tab really make it solid without over tightening the screw. The convenient size of the hex opening fits the standard nut without a special manufacturing step. All that said, one cant discount the obvious double use. Imho.
-
@turnsouth said:
So as I see it, all you need to do is take a Torx bit, place it in a bit driver, unscrew the fastener that is retaining the clip, remove the clip, take the Torx bit out of your bit driver, and then you can use the clip that you just removed with your bit driver as a bit driver.Is it just me, or...

Or you can find a thumbscrew to replace the torx screw.
-
@Accujohn said:
I actually think its intended as an added measure to avoid clip movement. The hex shape prevents any side to side. That and the little tab really make it solid without over tightening the screw. The convenient size of the hex opening fits the standard nut without a special manufacturing step. All that said, one cant discount the obvious double use. Imho.Again, i think leatherman found a clever way to make a cheap very solid clip without movement. I doubt the wrench idea was the main concern.
-
Looks quite ingenious, but I hope the clip is more secure than the one for the kick
-
and since you need a tool to remove the clip.....
Dual wielding leathermans!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login