Skeletool wire cutter binding.
-
The wire cutter on my new Skeletool "binds". By that, I mean the two sides come together a little too tightly, and it causes a noticeable extra amount of pressure to be required to open and close the pliers when the cutters are overlapping. My Freestyle doesn't have this issue at all, so I'm thinking it must be some sort of defect.
I know it seems minor but it actually makes using the tool one-handed quite a bit less comfortable. Is it worth sending it in to LM or should I try to fix it somehow?
-
You could probably file them down BUT I would send it to Leatherman if it was me.

-
I had the same problem on my CX before I sold it.
-
One of my Skeletools does this . I don't see it as a fault more like just tightness from a new tool . I bet it cuts paper and thin wire really well .
-
@Dunc said:
One of my Skeletools does this . I don't see it as a fault more like just tightness from a new tool . I bet it cuts paper and thin wire really well .I have to say that LM is one of the only wire cutters that seem to be able to cut paper straight out of the box as there cutters are tight, the pliers on my new PT in comparison are looser but still cut wire and thin steel easy but not paper, i hope you get it sorted but as Dunc said they will probably wear in, go cut some wires :D

-
Cutting paper? I tried that on my 154cm Cutters and that sliced like scissors. The swisstool pliers cut also just not as fine. Interesting fun test, thanks. Not sure what it says about cutting wire, but still cool
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login