MUT Question
-
Don't have a MUT yet, but a co-worker bought one for his M-16, and I noticed something. The round pin that slides back and forth to retain the stored bits does not seem to have enough tension in the center "stored" position. It slides open either way too easily.
Is this just because it is new and maybe has a little too much lube in there, or is he looking at a warranty issue?
Thanks
-
All 4 of my MUTs are tight tight. That def is something to look into for warranty, or at least if he bought it at a store, an exchange.
-
The sliding retaining pin on my MUT is OK. It stays where it should, and moves with a little moderate push to either side.
-
Yea, that's what I was thinking. I had handled one before and I remember the pin having a good positive "snap" to each of the three positions.
I'll let him know, I think he bought it from Amazon, so that should save him any shipping charges,
Thanks guys

-
Maybe a dash of oil in it. I think there is a detent ball in it.
-
I remember mine having a sure snap in all positions.
-
The Pin on my MUT slides pretty easily as well. Not a huge deal for me, as I keep it in a good case most of the time, and check it when I take it out to use, but maybe I should get it off to Warranty one of these days...
-
He is sending it back to Amazon, he came in this morning with the pin in his hand, total failure :(
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login