First SAK mod - 58mm Vagabond
-
It took a while, but I finally finished my Alox Vagabond mod!


It's a heck of a lot thinner than my Minichamp, and has all the tools I use the most. The peening could sure use some more work (thoe tiny pins are so hard to peen!! >:(), the tools are still kind of loose. Not enough to make the backsprings go out of alignment, but enough to annoy me:
By itself:

With pressure:

It's not a big difference, but I'd still like to fix it. Any tips on what I can do to tighten it?
-
You will need to get new pins and re peen it. Peen one side first before you put it together. Then on the other side after you put it together, leave about 1mm after you cut the pins. Peen slowly working around in a circle. Read the threads in the mod squad stickies. Good luck and nice first mod.
-
Thanks for the advice. I read the thread thinking that the whole 1mm thing for peening only applies to 91mm sak's, but I guess not!

-
Well done for having a crack at it
Plenty of people shy away from cracking open the little SAKs.Looking at the size of gap I'm afraid I agree with Steve, looks like you might have to redo it :(
Still, nothing to loose by getting a small parallel punch on those heads and giving it a few whacks to see if you can tighten things up.
-
@Neil said:
Well done for having a crack at it
Plenty of people shy away from cracking open the little SAKs.Looking at the size of gap I'm afraid I agree with Steve, looks like you might have to redo it :(
Still, nothing to loose by getting a small parallel punch on those heads and giving it a few whacks to see if you can tighten things up.
Oddly enough putting together these tiny things ended up being pretty easy. I used a Classic SD screwdriver to push back those tiny springs, and it made things so easy I didn't even have to use a jig :ahhh
I was hoping to fix the pins, but I think I filed them too short so I'll have to take the whole thing apart. Oh well, at least I have pin stock a plenty. By the way I don't know if anyone's found this out, but the pins for 58mm sak's are exactly 1/16 inch, so there's plenty of places to get them at in the US
-
Good luck with round two

-
Cool, hope you get it straightened out because it's a lovely little mod :D
-
that is a great little SAK mate, great bit of modding.

-
Thanks everyone, couldn't have done it without some help from this forum. I've taken the whole thing apart again for re-peening, and now I'm trying to figure out a layer for the tweezers and toothpick. I'll post some pictures asap!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login