Home made camp stoves
-
Okay. As requested. It's ugly, but it works.
First pic. This is the amount of fuel required, not counting some very small twigs to get it going. Vic Tinker for scale. It rained today, so everything is damp, including the wood you see here. The tin foil will later be used as a pot wrap, and the whole mess is set atop my little Smoky Joe grill to make it safe.

Here it is during initial ignition. I've never started one of these without some kind of assistance, usually a paraffin wax soaked cotton ball. I used 2 pieces, each a quarter of a cotton ball, to get it going this time. The damp fuel made things a bit more challenging than normal. From ignition to when it's operating normally ranges from maybe 7 to ten minutes or so, depending on how the fuel catches.

Okay, so here it is at about optimal burn. It's fairly hard to see the flames. At this stage, these things put off no visible smoke, and virtually no smell. Just a flame that's about 4 to 5 inches above the can top. By this point, the external can is radiating heat.

Here's my little 1-quart camping pot set on top, before I wrap it with aluminum foil. I designed this stove with a built-in pot stand: something lacking in every other design I've seen. That's what all the square holes are around the elevated portion of the inner can.

Boil time is about 11 minutes to slow boil (not rolling boil).

And here it is post-boil. You can see the wraps I used for the pot to each side of the stove. These coals will die down to nothing in half an hour or so.

Total burn-time was about 35 minutes, not including warm-up and the point after which the flames went out, leaving only hot coals. That would be enough to boil 2 quarts of water, with additional cook time with the hot coals afterward.
And, there you have it. A stove for the cost of two cans you were going to throw away, and half an hour's work of poking holes in them. I could make a less fancy version, without the more intricate pot-stand, in about ten minutes, I think.
-
Thanks Lynn

Nice set of pictures and the built in pot stand is a great idea


-
I think this little 'I need a coffee/pot noodle kit' is now finished, I took the little feet off the drainer as I don't think they are needed :-
I can't decide which burner to take, the one I made or the bought one which holds some meths with the lid screwed on
Just need to take/add coffee, milk, water and pot noodle :D

Its all fairly obvious
A - Pot holder
B - Meths burner
C – Meths
D – Stainless Pot
E – Wind screen
F – Fire starting kit
G – Home made Meths burner
H – Steel tent pegs
I – Shorty Spork
:D -
I like "F"...can we have a peek inside?
-
By the way thanks to everyone whose ideas I stole and everyone that helped me making this kit inc HK, Al and Gareth

Spork
Nothing that needs too much skill to use ;)Left to right top
Match case full of 'safety' matches and cotton wool
Ally box with some 'scratch' stuck on the side
Some pine 'sticks'
Tiny tin of VaselineGreen Heat
cotton wool mixed with Vaseline
Little lock knife
Orange whistle
LED flashlight
Tea-light
Light my fire 'fire-steel'
Green heat ;)
http://www.heinnie.com/product.asp?P_ID=3751 -
Nice
Though I was sure there was going to be a bottle of petrol inside ::) :D -
Don't know why you should think that

I need to thank you Spork
after I took that picture I was playing with the fire starting kit and tried to open the Vaseline, the lid fits so well a vacuum stopped me from getting the top off, I had to use two pairs of grips to open it :o
So I've added some more grip tape

-
I was thinking that another striker strip inside the lid might be a good ideal...in case things get wet on the outside.
-
Looking good mate

A clipper lighter is always a good choice in my opinion. More reliable than a cheapo disposable, and better fuel retention than a zippo. I notice you have some little pine sticks. Are they the fatwood sticks that you can buy, or just bits of pine you had kicking about?
A fire kit I built years ago had some emergency kindling which was wooden forks from the local chippy. I've always picked up more than one wooden fork at a chippy, as if I picked one up - you could guarantee I'd drop it or it would break on me. The extras that built up got split lengthways and put in a waterproof tin with some cotton wool
-
I will keep a look out for a clipper then

Just some clean dry pine that was kicking about in the garage to give me a little start ;) -
-
Great pictures Gareth

Tofty and I discovered at the meet that they really don't work very well in the wind :-[ so I've been thinking about some kind of wind break for them

-
Hey mate, it looks great! Burns like an olympic flame!
How fast is it compared to a Trangia, any idea?
I can't make out the potstand? Directly on top surely not?Ofcourse you could keep it nice and simple by using a cheap alu windshield (roll-up).
-
@Waterlander said:
Hey mate, it looks great! Burns like an olympic flame!
How fast is it compared to a Trangia, any idea?
I can't make out the potstand? Directly on top surely not?Ofcourse you could keep it nice and simple by using a cheap alu windshield (roll-up).
There's a bit more about them here Waterlander

A N Other stove
I use Meths for mine here in the UK
http://en.wikipedia.org/wiki/Methylated_spirit Oh, and the size of the holes make a big difference And the one I m...Multitool.Org Forum (multitool.ninja)
half a pint/300ml of cold water heated to boiling in 7min's in a tin can but might be quicker in a pan, I don't know about the trangia? :-\
If you follow the link you will see the pot sits on top of the burner but its not the most stable cooker in the world :ahhh
Cheap is my middle name, I am going to cut up another can and see what I can make
and I need to adjust my Ikea stove windbreak at the same time(I wanted a simple to use burner which is why the pot sits on top, less stuff to carry/forget,
So I'm defeating the original idea by adding a windbreak but at the meet it would not stay alight long enough to get up to operating temperature..... needs must
) -
Great thank you, I'm gonna check that later, good old backyard mechanics!

half a pint/300ml of cold water heated to boiling in 7min's in a tin can but might be quicker in a pan, I don't know about the trangia? :-\
**2:35 minutes ** (to a full rolling boil)
- cool tap water
- room temperature, indoors
- black stainless pot, with the lid on
- clickstand stove holder
- trangia pre-heated
Who will beat that? Bring it on :D
-
I will see what I can do over the weekend

There's one or two scattered around the UK so someone might beat me to it :D -
Here we go everything ready

Water from cold tap
Room temp 23c 75f ish in my workshop
Black stainless pot, with the lid on
Pot sitting on top of burner
Burner pre heated
Yep that's lit :ahhh

Looking good


3.5 Mins Later


maybe petrol would work >:D -
There's one or two scattered around the UK so someone might beat me to it
Where's the backup when you need them? :D
I brought two stoves on a camping trip this weekend, so I tried again outside.
Trangia - 2:55 min.
MSR - 2:05 min.
My petrol burner is an old and rather clogged up MSR Whisperlite.
maybe petrol would work
The secret is all in the pot..swiss made! ::)
Show off 'dem Canteen & Mess kits
This I use too, like more of you. :) These are older pics, but my little cooking set is basicly still the same. Trangia meth burner, Sigg stainless pot. Wor...
Multitool.Org Forum (multitool.ninja)
Rematch with a wood stove? :)
-
I shall have to do a time trial with my Wild Wood Gas Stove Combo (my latest stove) and my ever faithful Jetboil. Neither of them are home made, but it's nice to know how they fare against the home grown alcohol stoves.
Last time I used the wood gas stove was also the first time, when I figured out what NOT to do, and smoked out the neighbours

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login





