What Did You Use Your Multitool For Today?
-
Used my S2 to adjust a rear bicycle derailleur and tighten the clamp on the gear shift lever.
-
Used my wave to pull an upholstery staple out of my wife's grandmother's favorite chair (it had been sticking out and stabbing her)... Brownie points!
spelling mistakes and misinformation courtesy of Tapatalk
-
I used the blade on my spirit x today to cut open lots of shrink rap. That's all my knives get used for lately, cutting shrink rap off of beer pallets at work. It sounds awesome cuz beer is involved, but I assure you this is the dullest use of a knife I can think of.
-
Used the BO Fuse pliers to open the oil fill cap on the push mower then used to pull back the throttle a bit.
-
Pulled some staples and nails with my blast, opens paint cans with my pocket wrench and took of and put back some hinges and window locks. on after I cleaned them, scraped paint off windows with my scraper. No pic of that.




-
Used the main blade on my CT Lite to open new bags of Iams for our dog and cat, and last night I used the #0 phillips bit to replace the batteries in my daughter's full moon nightlight.
-
Yesterday I cannibalized the front office computer and upgraded it with a new case, motherboard, CPU, and RAM, plus spare parts in the form of an internal card reader; my Cybertool 41 came very much in handy.

-
I used my Wave to cut and strip the spark plug wires on my boat. I was replacing the boots and decided to pull some insulation back to allow the center lead to make contact with both the pin in the contact and direct contact on the spring itself. Worked like a charm, now my old 74 starts up without so much as a cough.
-
Opening a cellophane-wrapped book and screwing tripod plates to a camera body and lens.
-
Photographing a wedding: used my LM squirt's file to make some notches in a wooden hanger so i could hang & shoot the brides dress without it slipping off the hanger ;)
-
My brother used my 5WR Toolbox to hold a bolt while he ran up the nut to secure the leg on the new reloading bench.
-
Used My blast to take down a wire fence,put a battery cable on a dump truck and my Pw 2 on some large flat head screw's on a chainsaw.
I switched out to a sog 2.0 after work used it to tighten up my bbq grill.
Nitecore ezaa r5 to walk the Dog.
-
Yesterday:
Gerber Dime made a great gift for my sister.
SwissTool RX helped put a deck together.
Gerber MP600 helped defuse a bomb (seriously).
Leatherman Juice CS4 installed new windshield wiper blades.Today:
My daughter used her Squirt P4 to make a model UFO.
Tied my Leatherman Wave to a rope and threw it over the house, allowing me to tie the rope off and scale the side to remove a wasp nest. -
I used my Huntsman to repair my employers wheelchair while out for the day at Weston Super Mare (UK seaside town). One of the wheels was making weird noises because the screws securing the rim were coming very loose. Tightened up and fixed in 2 minutes!
-
-Used a Charge TTI to pick up a spark plug after back it fell back onto the engine block which was still hot
-Used a squirt PS4 help cut and strip wires to fix an XLR cable which broke. I'm wondering if I should've went with a ES4 instead. -
Skeletool CX today to aid with crib assembly for the new baby (arriving any day now).
-
I found one of my old military-issue Gerber MP600 EOD models while going through some boxes today. It helped me disarm many bombs while in the military.
In the same box was my original SwissTool RS, which I bought for my job as a Firefighter / EMT and thought it got lost when we moved. I looked through every box it might be in; turns out, it was in one marked "Delica's Toys".
Oh, I used my Leatherman Wave to help fix up the garage.
-
I used my surges' serrated blade to hotwire a school bus yesterday
-
Been using my Wave all week for opening cans, fixing my eyeglasses, sawing branches, cutting various things with both blades, and tearing stuff up in general.
-
I assembled a do-it-yourself barbeque with my skeletool and EDC pry tool today. Was quite nice because nobody had any tools with them and those two tools just had an answer for everything.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login