wave scissors problem
-
The scissors on my wave are almost unusable. Everyone i try to use them the spring bar goes out of place over the scissors sort of locking it close. Is my spring bar defective or do they all have this problem. If this is how they all come and its not warranty fixed i would probably be better off removing the spring bar and using the scissors without spring action
-
i don't quite understand what's happening on yours, but it sure sounds like something is very wrong.
mine are very 'springy' (as on other leatherman models, like the fuse etc) they are mostly awesome for such tiny scissors, get them looked at by an expert sir
-
Maybe these picd will explain it better.
1 is the scissors unfolded before use
2 is showing the problem with the over lapping spring bar


-
I had that once, but I pushed the scissor body into the spring a bit. It seemed to work.
It was also a factor of me loosening the pivots a bit and the parts not mating correctly.
-
@Metropolicity said:
I had that once, but I pushed the scissor body into the spring a bit. It seemed to work.It was also a factor of me loosening the pivots a bit and the parts not mating correctly.
that was what I was wondering. Coastalchris, do the tools have lots of (or even some) side to side movement? If so then you might be able to tighten the pivots up to solve the problem. If not then the spring arm might be bent, probably a job best solved back at Leatherman.
-
@coastalchris said:
Maybe these picd will explain it better.1 is the scissors unfolded before use
2 is showing the problem with the over lapping spring bar
your written description was pretty accurate coastalchris, but as they say "a picture says a thousand words" thank you sir.
i wouldn't say i'm in any way an expert, but your scissors shouldn't be doing that mate.
the two guys above are way more qualified to give you advice i'm sure, so i will agree with them :D -
I had a similar problem with the scissors on another brand of MT (possibly a SOG ?). I simply reprofiled the end of the spring (with a LM diamond file) and also where the spring touched on the body so when the spring was under pressure it pushed harder into the stationary scissor body rather than riding up and over the moving part of the scissors. IIRC I didn't have to take much metal off (less than one mm).
Looking at my TTi (same scissors as a Wave) I think you'd have to take the scissors out of the body to get to the places you need to change the profile.
-
I'd send it back to Leatherman and get them to replace it. Where abouts do you live ?
-
We have seen that on other tools but not on a Wave I don't think

I had the same thing on my Style PS before the spring snapped off altogether (there's been quite a few guys here who've had issues with the smaller LM scissors I think). A couple people have had it on their Gerber Dimes, but mine have been perfect, and I did have a problem with some PST II scissors disengaging (that I'd built into another tool) before I gave them a good whack with a hammer

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login