Show off your Sak mod's!
-
Sure! :tool:



-
NICE!!
JR -
Hope the capt don't mind me showing this off.

OD green and black tooled alox. With saw and file :). One of my last mods.
-
^Nice work as always Steve.
She"s a Green and black beauty
-

Modded my trusty Compact today. Removed the keyring spacer for a flush one (donated by an Explorer) and replaced the Parcel Hook spring with a classic good ol' scissors spring. Combined with latest gen scissors, this creates an ultra snap.

Also, I finally have a flush spring on the back. The new springs with the backside tools are always recessed. I don't like this at all. -
That´s a nice idea.

-
It's the spring you sent me. :D
I sent you an email btw.
-
I know what you mean about the springs not being flush annoying. Thats one edge Wenger SAKS have, nice flush liners and springs. I dont mind backtool SAKs so much, but i dont like the poking out liners at all.
Look how nice the back of the Wenger on the left looks.

-
Compact with pliers and saw layer added. The only unusual part on this one is I put an awl where there is normally a fine screwdriver under the saw. I had to shave 0.015 inches off a liner so it would fit. Works fine though.




-
@Syph007 said:
Compact with pliers and saw layer added. The only unusual part on this one is I put an awl where there is normally a fine screwdriver under the saw. I had to shave 0.015 inches off a liner so it would fit. Works fine though.



Dang near the perfect EDC SAK..
Only needs a file and maybe alox scales and I would never need another SAK.. Great work.. :) -

Just wanted to share my Alox trifecta.

-
Triple threat

-
-
I second the metal file suggestion BTW. :)
-
Tried golden screws on a new Farmer with scissors mod. I like it. Combines both looks. :tool:

-
nice!
where did you get them?
-
My latest mod:


I really like this one a lot. It's my new EDC. I'm going to take it back apart to do some fine tuning (more snap) and then slap on a pair of black scales, since I got krazy glue on the translucent ones
.I also found a precision 40 piece Wiha bit set that works with the bit driver. I got a small neodymium magnet & krazy glued it in there to hold them in place. So far it's working surprisingly well :D I'm thinking about putting magnets in all the bit holders as well.
Edited to add:
+1 on the screws
crackout, that looks sweet. What does the other side look like or are they Chicago screws?
-
good idea on magnets
funny i was at home depot and saw a small precision set of drivers and wondered if they would fit...
i said it in your thread but again fantastic work.
this mod should make the scissors guys go bonkers,
any ideas for a name?
-
It's still using threaded pivots like Syph's models. I only went for these this time:
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
