Weekend project.
-
Heat will make the magnet fall out :). And slow grind the sides till it fits properly :)
-
Awesome. That's what I was thinking. Thanks
-
Anytime! Keeps up updated on the project and always pics please

-
i'd use a beltsander or an endmill if you got one
-
progress! Well it fits the bit exchanger. The propane torch worked amazing to remove the magnet. It will fit the LM bits but without a magnet they fall right out.
-
will it hold 1/4" hex fit?
-
Yes, however without the magnet the bit falls out.
-
Have you tried to magnetize the whole bit holder ? (won't work if it isn't the right steel).
-
You may be able to get a smaller magnet that will work too ;).
-
This is worse than legos when I was a kid!


-
What's wrong with the LM extender and bit kit? I've always thought about making my own, but the time it would take me to make one that I like, it would have been easier to spend $10 :)
-
The lm bit extender is great with the lm bits but the little stubby bits fall down too deep and are a pain in the ass to get back out.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

