Remove Rust and cleaning tip
-
It depends a lot on the finish of your tool and the steelwool you have, as you may scratch the finish of your tool. Also the amount of rust. There is a similar thread from the past few days too.
I use a rust removing oil and steelwool/wirebrush on rust, followed by a good polishing if needed. You may have to take it apart to get any hidden rust.
-
Cheers, what do you use to polish? Something like autosol?
-
Brasso if needed, polishing wheel... Wait a bit as there will be several people with a lot more expertise to advice you.
-
I haven't met any rust yet that didn't respond to fine steel wool, and some Mothers Aluminum polish afterwards. The Mothers says it leaves a coating behind that helps slow oxidation/rust. Lube the joints and it's ready to go.
Only time I ever needed to partially dis-assemble a tool to get at stubborn, hard-to-reach rust, was undoing a pair of screws on the handle of a SOG Cross-cut. That was a fast job though.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login