Esbit 585 cookset?
-
Gareth, I’m usually able to get to a boil or at least a “rope of pearls” using one tablet and 400ml of water. Explanation of Chinese Boiling terms here – Boiling
I just ran a test using one Esbit tablet with 350ml and got a rolling boil at 9:14, sustained to 12:29 minutes.
I’ve tried a number of different alcohol burners with the 585. I feel that un-jetted, un-pressurized burners are best suited for it. I’ve tried miniature Penny and Pepsi stoves and experienced overheating and runaway because they got overheated in the small space. The majority of the time the fuel would vaporize too quickly and run out before even “shrimp eyes” was achieved. I’ve also had poor luck with alcohol burners if the pot is sitting on the stand as designed…so I raise it up using a 90mm computer fan grill. You’ll get tall flames the height of the pot. I make sure to align the handles with the large port to avoid melting the insulation…because of the incoming air, the tall flames don’t seem to emerge in that section.
I’ve tried various open cup configurations ranging from an empty tea candle cup to tins filled with various types of insulation. The burner shown in the photo is a 1oz slip top tin filled with a couple of layers of carbon felt. Having the insulation is advantageous because the fuel is held by the felt and spills are avoided. The lid protects the felt for transport and can be used for snuffing.
Using the grill and burner I ran 400ml twice on 1 oz of denatured alcohol.
Rolling boil @ 6:47, runout @ 8:37 minutes
Rolling boil @ 7:05, runout @ 8:18 minutes
-
shrimp eyes
about 70-80 °C (155–175 °F) – separate bubbles, rising to topcrab eyes
about 80 °C (175 °F) – streams of bubblesfish eyes
about 80-90 °C (175–195 °F) – larger bubblesrope of pearls
about 90-95 °C (195–205 °F) – steady streams of large bubblesraging torrent
rolling boil, swirling and roilingI like those. :D I think I got it to fish eyes before I ran out of fuel. Now I admit I wasn't timing it but I doubt very much that I got anywhere near 12 minutes out of it.
Also the air temp (about 4deg C) and breeze could easily have affected the results.I'll definitely give it another go though, I've got quite a few tablets to get through. ;) I've also got a couple of meths burners to try as well. I wonder if a standard Trangia burner will sit nicely in it? Need to give that a go as well. :)
-
OK so I've just had another go with the tablets and the results were a little better. Still fell short of actually managing a full rolling boil but was certainly hot enough for a nice cup of coffee. Again I was using 350ml of water, a single tablet and the temperature was 10deg C with a light breeze. I suspect it's the breeze that's scuppering my attempts to reach 100deg C.
I did at least get roughly 12 minutes of burn time from the tablet. -
Esbit is possibly more sensitive to wind than alcohol. Using a secondary windscreen made from heavy foil is worthwhile. I get disposable foil chafing dish covers from the party supply store.
-
I'm quite surprised that a rolling boil isn't reached after 12 mins :-\ I'd defo try the secondary windshield that Spork suggested
Disposable foil serving trays for buffets/BBQs work well and are cheap enough at supermarkets -
Some kind of wind screen sounds like an excellent idea. I'll knock something up and do another test. :)
-
@Gareth said:
...I wonder if a standard Trangia burner will sit nicely in it? Need to give that a go as well. :)I just checked against the 985 cookset. Although it will fit inside, I don't think it is tall enough...even with the tray removed you'll only have about 10mm of free space to the top of the stand. That will be less once the pot is in place. In comparison, the 985 set measures about 32mm from top of simmer cap to top of stand.
Factory distance for a Trangia 27 is about 19mm
-
The wind screen I made is 3-1/8" (8cm) high and can be stowed rolled-up inside. It is shorter than what I would want on a solid surface but in actual practice the stand can be placed in a shallow depression scooped in the dirt to effectively increase the coverage.


-
I've made a shield pretty much exactly the same size now. Kitchen foil folded over several times makes for a surprisingly sturdy piece of metal.
-
@Spork, Lord of Lime Jello! said:
...I wonder if a standard Trangia burner will sit nicely in it? Need to give that a go as well. :)
I just checked against the 985 cookset. Although it will fit inside, I don't think it is tall enough...even with the tray removed you'll only have about 10mm of free space to the top of the stand. That will be less once the pot is in place. In comparison, the 985 set measures about 32mm from top of simmer cap to top of stand.
Factory distance for a Trangia 27 is about 19mm
Yeah, I see what you mean. :-\ Very, very little clearance between the burner and pot bottom, even with the simmer ring in place I could easily imagine flames licking everywhere. Might still light it up and see though. :D
-
OK third test now done. SUCCESS! With an air temperature of about 10deg C and little to no breeze (plus the home made wind shield) I got 350ml of water to a rolling boil in around 6 minutes. :o Obviously this kit is very wind sensitive but if you can keep it sheltered then it works just fine.

One thing to note though; watch out for the sticky black residue left on the bottom of the pan from the bruning fuel tablet. :-\
-
I knew you could do it :D All it takes is a bit of experience and proper management.
I've been playing with an Esbitmizer lately and have managed to cook rice (1/2 cup plus 3/4 cup water) on one and a half tablets. Besides getting it to a boil there was a simmering time of 15 minutes.
The residue cleans up fairly easily with hot water.


-
Glad to hear you've got it running properly

@Gareth said:
One thing to note though; watch out for the sticky black residue left on the bottom of the pan from the bruning fuel tablet. :-\An old ex-army guy once told me he rubbed soap on the bottom of the pot before cooking, and often just rubbing the pot in dirt/grass after would fetch the vast majority off .... I never tried it though
-
The gunk does come off the pot very easily, but I'd not fancy trying to get it off clothes.
-
@Spork, Lord of Lime Jello! said:
I knew you could do it :D All it takes is a bit of experience and proper management.I've been playing with an Esbitmizer lately and have managed to cook rice (1/2 cup plus 3/4 cup water) on one and a half tablets. Besides getting it to a boil there was a simmering time of 15 minutes.
The residue cleans up fairly easily with hot water.
Nice set up !
-
So, just a couple of years after I started talking about it I finally got around to getting rid of the plastic feet.

If there's one thing my garage isn't short of, it's chips of wood and shavings.

A little fire was easy to get going and you can see the bolts I've used to replace the plastic feet.

Easiest way I found to keep it fed was to take large curls of wood off and feed them in the opening.

Start to finish (boiling water for a cup of coffee) took around 15 minutes, but that includes a bit of faffing about getting the right sized pieces of wood to feed it.

-
A least this necro was a useful one ::)
Perhaps raising the pot up a bit with a fan grill would lower the time a bit...increase the draft and allow more flame contact.
-
@Spork, Lord of Lime Jello! said:
A least this necro was a useful one ::)Perhaps raising the pot up a bit with a fan grill would lower the time a bit...increase the draft and allow more flame contact.
I'd forgotten about that suggestion you made (well, it was a few years ago) and I do definitely think it's a good one.

-
I dug mine out for a play...16oz of water and gel fuel...
12:51 to rolling boil in normal position...9:03 raised on a grill. I do need to make a taller windscreen for it...the one that stows inside is too low when used on a solid surface.

-
I've been trying mine with some Dragon Fire gel fuel and with some meths, both just put in a old air rifle pellet tin. I didn't take any exact times, but the meths had 350ml of water up to a rolling boil in around 8 minutes, the Dragon Fire took nearly twice that.
I did go looking at the back of an old PC I had kicking around, but it doesn't have that style of fan grill. :-\
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login