The Splash - LM Squirt Mod
-
So, how thick is it getting?
-
Should be about .65" thick
-
Not bad
-
That is still very pocketable and you are packing a lot of options in there.
-
That is still very pocketable and you are packing a lot of options in there.
pretty much everything I would find in one of my big tools, but smaller.
I have a Skinth made for it already :)
Awwwww..... need to see that!

-
Easier to find if you lose it too.
-
Great mod work! and nice Skinth too
:D -
That is superb! Teeny weeny baby Skinth :D
-
I'd be interested in a skinth that color for my Climber if you have any
:) -
I'd be interested in a skinth that color for my Climber if you have any
:)Order the s-shield :)
Thanks, I'll do that. BTW, I just looked at your selection of Skinths and its amazing. These are the most awesome sheaths I've ever seen. GREAT work!

-
The pivots came in today. Good thing I bough extra, I already botched one. The threads are so small that I torqued one of the button heads off. No matter.
The 1/2" long pivots were too short, to make up the extra length, I took two pivots an cut them to length, the spliced them. This have me a .68" long pivot. I then turned them on the lathe with some 400 grit to get them nice and smooth.
I am still missing the S4 nail file and I may take out the other file all together and try to make a toothpick/pin/poker thing to slide into another one of the tweezer slot layers. I also stole the scales off another torx pinned ps4
In any case, here are some pics! It's a nice little square block of steel, plastic and aluminum.




The second file is in there as a place holder till the S4's come in, as mentioned the file may come out in favor of another tweezer layer.



I am really digging the extra width for the knife and scissors usage.


The plier grip is pretty good too.


On other design notes, I think I may design some new scales to print in stainless steel. Include some ruler indentations, maybe 1/4" bit hex hole.
-
Nice! It looks like a big full size tool, then when you have it in your hand you can really see the scale.
-
The extra width seems worth it in this case. The ratio of tools to bulk definitely increases for the better.
-
You got a good bit of tool in that one Eric
Looks great 
-
Ok, I think I have a problem. I can't seem to stop doing work on this tiny tool. I made another SE, this time with a much less aggressive pattern. I first made the curves with the large stone bit, the made the small scallops with a diamond bit. The I angled the same diamond big and profiled the large scallops. Finished off with an over all 400 grit sanding followed by a backside sharpening on an overturned belt sander. I'll install it when the nail file gets here to minimize the disassembly and reassembly time.




Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

