Blast in bits!
-
One between each tool

Note: The washers have small flats in the bore which correspond with the small flats on the pivot pins, which means they can be a chuff to put back ::) Reason for this is to stop the washer spinning on the pin and drawing the adjoining tool out ... anti-clumping design

-
Yeah I sort of worked that bit out, but I have 7 of the notched washers which are like shims very thin, and I have 3 thicker washers with no notch cut into them. Every time I re assemble it just doesn't feeli right.
-
THIS THREAD has a great end view of the tool which might help

-
Yep that done it, nice one buddy!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login