skeletool CX scam?
-
Could be possible the CM154 marking never got applied. Wished was a easy way to check the hardness of steel.
Can sort of tell the hardness of the steel when sharpening with a Spyderco TASM. That comes with years of use though. Physical looks don't think you can tell the differences.
-
@baja820 said:
I ordered a Skeletool cx from Amazon. It was sold to me as "new". This is how it arrived:



Is it possible that the 154cm blade is simply not marked or is someone trying to sell me a cx with a 420hc blade?The 420 blades are stamped and the 154cm ones are laser cut. The edges of the blade should have sharper corners on a 154 than on the 420.
Also, there are no known PE 420 Skele blades, only came in CE. The 154 was the only one that was available in either the CE or PE.
I all likely hood, the laser etching was missed on this one.
-
Thanks Metro, good info.

-
When skeletool first came out 420HC is PE whereas 154cm is CE. That was a few years back though so someone having a new 420HC PE to swap onto this one is pretty unlikely.
-
Just a guess, but it looks like it was ground down from a ce. The ce blade on my skele and freestyle both have,for lack of better term, a mini choil between the first hole and the thumb hole. This one does not, as theblade appears to have less belly, hence my hypothesis. Thoughts?
-
Here's mine Skeletool 420 PE! :P


-
@SAKnight said:
Just a guess, but it looks like it was ground down from a ce. The ce blade on my skele and freestyle both have,for lack of better term, a mini choil between the first hole and the thumb hole. This one does not, as theblade appears to have less belly, hence my hypothesis. Thoughts?The CE on those are pretty deep, so if you ground them off you wouldn't have much of a blade left.
Take a look at the edges of holes on blade, as metro said you should be able to tell the difference between a punched hole and laser cut hole. The former has inward rounded edge on front but sharp edge on the back, whereas lasered are 90° sharp on both sides.
-
@armèe-suisse said:
Here's mine Skeletool 420 PE! :P

OOO! I stand corrected!
-
Upon closer inspection it would appear this is laser cut not stamped.

-
@jzmtl said:
Take a look at the edges of holes on blade, as metro said you should be able to tell the difference between a punched hole and laser cut hole. The former has inward rounded edge on front but sharp edge on the back, whereas lasered are 90° sharp on both sides.Good find on you & Metro! :D

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login